ResourcePlant Protection Product ComparisonPlant Protection Product ComparisonReport inaccuraciesReport inaccuracies

DIRECTIONS FOR USE
It is a violation of Federal law to use this product in a manner inconsistent with its labeling.
READ ENTIRE LABEL. USE STRICTLY IN ACCORDANCE WITH PRECAUTIONARY STATEMENTS AND DIRECTIONS, AND WITH APPLICABLE STATE AND FEDERAL REGULATIONS.
Do not apply this product in a way that will contact workers or other persons, either directly or through drift.
Only protected handlers may be in the area during application. For any requirements specific to your State or Tribe, consult the agency responsible for pesticide regulation.

GENERAL INFORMATION
Resource Herbicide is a selective herbicide for postemergence control of susceptible broadleafweeds in field corn and soybeans.

GENERAL RESTRICTIONS AND LIMITATIONS
Do not apply this product through any type of irrigation system.
Do not make more than two applications per acre per season.
ENVIRONMENTAL CONDITIONS AND BIOLOGICAL PERFORMANCE
For best results, Resource should be applied to actively growing weeds within the growth stages indicated in this label. Applying Resource under conditions that do not promote active weed growth will reduce herbicide effectiveness. Do not apply Resource when the crop or weeds are under stress due to drought, excessive water, extremes in temperature, disease or low humidity. Weeds under stress tend to become less susceptible to herbicidal action. Resource is most effective when applied under sunny conditions at temperatures above 70°F.

RAIN FASTNESS
Resource is rainfast one hour after application. Applications should not be made if rain is expected within one hour of application or efficacy may be reduced.

MIXING INSTRUCTIONS
1. Fill spray tank with water 1/3 to 1/2 of desired level with clean water.
2. While agitating, add the required amount of Resource. Agitation should create a rippling or rolling action on the water surface. If tank mixing Resource with other labeled pesticides, add water soluble bags first, followed by dry formulations, flowables, emulsifiable concentrates and then solutions. Prepare no more spray mixture than is required for the immediate spray operation.
3. Add any required adjuvants.
4. Add any required nitrogen source, unless ammonium sulfate (AMS) is being used. If AMS is being used as the nitrogen source, it should be added after water soluble bags and before dry pesticides.
5. Fill spray tank to desired level with water. Agitation should continue until spray solution has been applied.
6. Mix only the amount of spray solution that can be applied the day of mixing. Resource will remain active in the spray solution for 12 hours.