Sharda Chlorimuron + Metribuzin WDG

Manufacturer
Sharda
Category
Herbicides
Registered until
N/A
Registration number
83529-41
Active materials
Links

DIRECTIONS FOR USE
It is a violation of Federal law to use this product in a manner inconsistent with its labeling.

Do not apply this product in a way that will contact workers or other persons, either directly or through drift. Only protected handlers may be in the area during application. For any requirements specific to your State or Tribe, consult the agency responsible for pesticide regulation.

NON-TARGET ORGANISM ADVISORY
This product is toxic to plants and may adversely impact the forage and habitat of non-target organisms, including pollinators, in areas adjacent to the treated area. Protect the forage and habitat of non-target organisms by minimizing spray drift. For further guidance and instructions on how to minimize spray drift, refer to the SPRAY DRIFT MANAGEMENT section of this label.

This product is a water dispersible granule herbicide that is mixed with water and sprayed for selective burndown and residual weed control in soybeans. This product provides control of many broadleaf weeds when used at specified label rates, and will provide partial control of annual grasses and nutsedge. Rainfall or sprinkler irrigation is required to activate this product for residual applications. Weed control and duration of control depends on rate used, weed spectrum, growing conditions at and following treatment, soil pH, soil texture, percent organic matter, amount of moisture and precipitation.
Optimum weed control occurs when this product is applied to moist soil that receives rainfall or irrigation (1”) before weed germination. Multiple rainfalls or irrigation of <1/4” each is not as effective as one rainfall/irrigation of 1/2” - 1”. If soil is dry, use 1” - 2” moisture pre-emergence to activate this product. If moisture is insufficient to activate this product, rotary hoe or shallowly cultivate after emergence of soybeans while weeds are small enough to be controlled mechanically.
Soybean stunting can occur if excessive rainfall occurs and soybeans haven’t germinated. Stunting is more prevalent under poor drainage conditions or when soil is saturated for extended periods of time. Soybeans will rapidly outgrow stunting as soon as favorable growing conditions return.

PRODUCT USE DIRECTIONS
x Apply this product any time after fall harvest, but prior to soybean emergence.
x Use clean water only to calibrate sprayers. Keep water away from the well site.
x Spray equipment must be checked and calibrated regularly.
x Dilute and agitate excess solution and apply at specified rates and/or uses listed on this label.
x Measure this product accurately.
x Triple-rinse the pesticide container after emptied, and add rinsate to the spray tank.
x Thoroughly clean all application equipment immediately after use and prior to spraying crops other than soybeans.
x Review crop rotation plans before applying this product to avoid injury to crops other than soybeans.
x Review the “Rotational Information” sections for your geographical region prior to applying this product.
x Split applications (two applications that total the full product application rate) can be made in a soybean cropping cycle.
x Check with the soybean seed company if a soybean variety if suspected of being sensitive to metribuzin prior to application of this product.

PRODUCT USE RESTRICTIONS
x Do not apply this product after soybeans have emerged.
x Do not apply this product through any type of irrigation system.
x Do not mix more product than what is required for the application at hand.
x Do not overfill the spray tank.
x Do not spill excess material onto the soil at any single location in the field and/or mixing/loading station.
x Do not store this product near any well site.
x Do not allow direct or indirect contact of this product to crops or land scheduled to be planted to crops other than soybeans.
x Do not use this product in geographies other than those listed in the “Rotational Information” sections of this label.
x Do not apply this product, or drain or flush equipment near desirable trees and other plants, or onto areas where their roots may extend, or in locations where this product may be washed or moved into contact with their roots.
x Do not use this product on lawns, walks, driveways, tennis courts, or similar areas.
x Do not allow spray to drift to desirable plants.
x Do not contaminate any body of water with this product.
x Do not mix/load, or use within 50 feet of wells, including abandoned wells, drainage wells, and sink holes.
x Do not store this product with other fertilizers, insecticides, fungicides, and seeds.
x Do not graze treated fields or harvest for forage or hay.
x Do not apply this product with low pressure/high volume hand wand equipment.
x Do not make more than one single application at the full product application rate in soybeans per acre per year.
x Do not apply more than 12 oz. of product (0.48 lb. a.i. metribuzin and 0.08 lb. a.i. chlorimuron) per acre per year.
x Do not exceed the full specified label rate for any geographical region.
x Do not apply to frozen ground.
x Do not tank mix this product with organophosphate insecticides.
x Do not apply this product within 14 days before or after application of an organophosphate insecticide.
x Kansas/Nebraska state specific restriction: Do not apply in land that has been or will be treated with metsulfuron and/or chlorsulfuron-containing herbicides without observing the rotational crop intervals.
x Do not apply this product to varieties of soybeans that are sensitive to metribuzin.

Registered for cultures
Soybeans
Spring barley
Winter barley