Spray Oil 470

Manufacturer
WinField
Category
Insecticides
Registered until
N/A
Registration number
9779-1011
Active materials
Links

DIRECTIONS FOR USE
It is a violation of Federal law to use this product in a manner inconsistent with its labeling.
Do not apply this product through any type of irrigation system.
Do not apply this product in a way that will contact workers or other persons, either directly or through drift. Only protected handlers may be in the area during application. For any requirements specific to your State or Tribe, consult the agency responsible for pesticide regulation.

MIXING DIRECTIONS
Use only in equipment with sufficient agitation to keep spray thoroughly mixed. Be sure tank is clean. With agitator running, start filling tank with water; add SPRAY OIL 470 when tank is about ~ full. Pump this mixture through the overflow and back into tank for about two minutes. If this mixture tums white, it indicates good emulsification. Fill the tank with water, adding other desired materials as tank is filling. If wettable powders are used, add and thoroughly mix with water before adding SPRAY OIL 470. Addition of an emulsifiable formulation should be done after the SPRAY OIL 470 and water has been thoroughly mixed. Observe all precautions and limitations on labeling of all products used in mixtures. Keep agitator running at all times. If an injector is used, first add 25 to 50 gals. of water to tank with engine running to provide good pressure. Put injector suction tube into the measured amount of SPRAY OIL 470, opening injector valve to allow the SPRAY OIL 470 to be sucked into the tank, then fill the tank with water. Do not use if this material does not emulsify.

APPLICATION DIRECTIONS
Apply when pests are present and as specified on this label. Do not use in undiluted form. Sensitive foliage may be injured.

GROUND APPLICATIONS:
To ensure thorough coverage, dilute applications (greater than 150 gallons of spray solution per acre) should be made. Concentrate applications (usually from 20 to 150 gallons of spray solution) may reduce the coverage and thus the effectiveness. Application volumes depend On the crop type, crop size and target pest. Adjust the spray volume to obtain the best coverage without runoff. Extreme care should be taken when using concentrate sprays as the potential for enhanced crop phytotoxicity is increased. A concentrate application can provide satisfactory results as long as the spray unit is properly engineered, calibrated and operated.

AERIAL APPLICATIONS:
Dormant and Delayed Dormant Application Only: Apply 3 to 5 gals. in a minimum of 20 gals. of water per acre. Use only as an emergency application when soil conditions or site does not permit regular ground application. This product has not been tested on all species or varieties. Before treating a large area, treat a small area and observe prior to full scale application.

Registered for cultures
Almonds
Apricots
Cherries
Apples
Figs
Grapes
Olives
Peaches
Nectarines
Pears
Plums
Walnut
Citrus