Star 650Plant Protection Product ComparisonPlant Protection Product ComparisonReport inaccuraciesReport inaccuracies

INFORMATION
Performance of this product may be affected by local conditions, crop varieties, and application method.
User should consult local Extension Service, Agricultural Experiment Station or University Weed Specialists, and state regulatory agencies for recommendations in your area. Best results are obtained when product is applied to young succulent weeds that are actively growing. The lower recommended rates will be satisfactory on susceptible annual weeds. For perennial weeds and conditions such as the very dry areas of the western states, where control is difficult, the higher recommended rates should be used.
When product is used for weed control in crops, the growth stage of the crop must be considered. Some plants and weeds, especially woody varieties, are difficult to control and may require repeat applications.
Application rates should be 1 to 5 gallons of total spray by air or 5 to 25 gallons by ground equipment unless otherwise directed. In either case, use the same amount of 2,4-D recommended per acre. For crop uses, do not mix with oil, surfactants, or other adjuvants unless specifically recommended. To do so may reduce herbicide's selectivity and could result in crop damage.
Many states have regulations concerning aerial application of 2,4-D formulations. Consult local regulatory authorities before making applications. Although this product is a low volatile formulation, at temperatures above 90°F vapors may damage susceptible crops growing nearby.
Product should not be allowed to come into contact with desirable, susceptible plants such as beans, cotton, fruit trees, grapes, legumes, ornamentals, peas, tomatoes, and other vegetables. Product should not be used in greenhouses. Excessive amounts of this product in the soil may temporarily inhibit seed
germination and all plant growth.
If stored below freezing, efficacy is not affected if product is warmed to 40°F and agitated before using. Spray equipment used to apply 2,4-D should not be used for any other purpose until thoroughly cleaned.
Spray Preparation:
Add the recommended amount of product to approximately 1/2 the volume of water to be used for spraying. Agitate well, then add the remainder of the water. Continue agitation during application until spray tank is empty.