Weedone LV6 EC

Manufacturer
NUFARM
Category
Herbicides
Registered until
N/A
Registration number
71368-11
Links

DIRECTIONS FOR USE
It is a violation of Federal law to use this product in a manner inconsistent with its labeling. READ ENTIRE LABEL BEFORE USING THIS PRODUCT. USE STRICTLY IN ACCORDANCE WITH LABEL PRECAUTIONARY STATEMENTS AND DIRECTIONS.
Do not apply this product in a way that will contact workers or other persons, either directly or through drift. Only protected handlers may be in the area during application. For any requirements specific to your State or Tribe, consult the agency responsible for pesticide regulation. Product should not be used in or near greenhouses.

PRODUCT INFORMATION
This product contains isooctyl ester of 2,4-D. In cropland, this herbicide is for controlling hard-to-kill weeds such as bindweed, thistle, smartweeds, wild garlic, curled dock, tansy ragwort and wild onions. INJURY TO CROPS FROM THIS HERBICIDE MAY OCCUR. IF YOU ARE NOT PREPARED TO ACCEPT SOME DEGREE OF CROP INJURY, DO NOT USE THIS PRODUCT.
Crop varieties vary in response to 2,4-D and some are easily injured. Apply this herbicide to varieties known to be tolerant to 2,4-D. If you are uncertain concerning tolerant varieties or local use situations that may affect crop tolerance to 2,4-D, consult your seed company, state Agricultural Extension Service or qualified crop consultant for advice.

PRODUCT RESTRICTIONS
Do not apply this product through any type of irrigation system.
Do not use in or near a greenhouse.
Do not use the same spray equipment for other purposes unless thoroughly cleaned. Crops contacted by sprays or spray drift may be killed or suffer significant stand loss with extensive quality and yield reduction.

MIXING INSTRUCTIONS
Add 1/2 the required amount of water to the spray tank, then add this product with agitation, and finally, the balance of the water with continued agitation. This material forms an emulsion in water, not a solution. This tends to separate on standing. Provide agitation to prevent such separation and insure uniform spray mixtures.

COMPATIBILITY
If this herbicide is to be tank mixed with fertilizers or with other pesticides, test compatibility prior to mixing.
To test for compatibility, use a small container and mix a small amount (0.5 to 1 quart) of spray, combining all ingredients in the same ratio as the anticipated use. If any indications of physical incompatibility develop, do not use this mixture for spraying. Indications of incompatibility usually will appear within 5 to 15 minutes after mixing.
Read and follow the label of each tank mix product used for precautionary statements, directions for use, geographic and other restrictions.

APPLICATION INSTRUCTIONS
Apply with calibrated air or ground equipment using sufficient spray volume to provide adequate coverage of target weeds or as otherwise directed in specific use directions.
For aerial application - Do not apply less than 2 gallon total spray volume per acre.
For ground applications - Do not apply less than 10 gallon total spray volume per acre.
The higher spray volumes will be needed under the following circumstances:
• For difficult to control vegetation,
• For large vegetation,
• Under conditions where control is more difficult, or
• When tank mixing with oils.

Registered for cultures
Winter wheat
Spring wheat
Spring barley
Winter barley
Millet
Spring oats
Winter oats
Winter triticale
Spring triticale
Winter rye
Spring rye
Corn
Fallow
Potatoes
Sorghum
Soybeans
Pasture