AC Clatter 900WGPlant Protection Product ComparisonPlant Protection Product ComparisonReport inaccuraciesReport inaccuracies

GENERAL INSTRUCTIONS

Application

Dilute Spraying:

• Use a sprayer designed to apply high volumes of water up to the point of run-off and matched to the crop being sprayed.

• Set up and operate the sprayer to achieve even coverage throughout the crop canopy. Apply sufficient water to cover the crop to the point of run-off. Avoid excessive run-off.

• The required water volume may be determined by applying different test volumes, using different settings on the sprayer, from industry guidelines, or expert advice.

• Add the amount of product specified in the Directions for Use table for each 100L of water. Spray to the point of run-off.

• The required dilute spray volume will change, and the sprayer set up and operation may also need to be changed, as the crop grows.

Concentrate Spraying:

• Use a sprayer designed and set up for concentrate spraying (that is a sprayer which applies water volumes less than those required to reach the point of run-off) and matched to the crop being sprayed. Eg: Low volume air blast.

• Set up and operate the sprayer to achieve even coverage throughout the crop canopy using your chosen water volume.

• Determine an appropriate dilute spray volume (see dilute spraying above) for the crop canopy. This is needed to calculate the concentrate mixing rate.

• The mixing rate for concentrate spraying can then be calculated in the following way:

  EXAMPLE ONLY: i) Dilute spray volume as determined above: For example 1500L/ha ii) Your chosen concentrate spray volume: For example 500L/ha iii) The concentration factor in this example is: 3 x (i.e., 1500L ÷ 500L = 3) iv) If the dilute label rate is 10mL/100L, then the concentrate rate becomes 3 x 10, that is 30mL/100L of concentrate spray.

• The chosen spray volume, amount of product per 100L of water, and the sprayer set up and operation may need to be changed as the crop grows.

• For further information on concentrate spraying, users are advised to consult the relevant industry guidelines, undertake appropriate competency training, and follow industry Best Practices.

Mixing: Half fill spray vat and with agitation system running, add the required amount of product. Top up with water to the required volume. The product must be kept in suspension at all times by continuous agitation. Where prepared spray mixes have been allowed to stand, thoroughly re-agitate before using.

Application rates per hectare:

• Low Volume - 200 litres or more.

• High Volume - 500 litres or more.

• Aerial Application - 20 litres or more.

• Mister - 75 - 255 litres.

The volume of water applied should increase as the plants grow in size to maintain adequate cover.

Compatibility: This product is compatible with wettable powder and flowable formulations of most commonly used fungicides, insecticides, and miticides. Unless experience in your area has shown other combinations to be physically compatible and non-injurious to your crop, do not combine with other chemicals, especially oil-based emulsifiable or flowable pesticides. This product should not be mixed with spraying oils or sprayed onto crops that have been sprayed with oil for at least 10 days after the last spray.

Wetting Agents: The addition of surfactants does not improve this product’s efficiency and under some conditions may cause plant injury.

Fungicide Resistance Warning

GROUP M5 FUNGICIDE

AC Clatter 900 WG Fungicide is a member of the multi-site activity group of fungicides. For fungicide resistance management, the product is a Group M5 fungicide. Some naturally occurring individual fungi resistant to AC Clatter 900 WG Fungicide and other Group M5 fungicides may exist through normal genetic variability in any fungal population. The resistant individuals can eventually dominate the fungal population if these fungicides are used repeatedly. These resistant fungi will not be controlled by AC Clatter 900 WG Fungicide or other Group M5 fungicides, thus resulting in a reduction in efficacy and possible yield loss. Since the occurrence of resistant fungi is difficult to detect prior to use, Axichem Pty Ltd accepts no liability for any losses that may result from the failure of AC Clatter 900 WG Fungicide to control resistant fungi.

CAUTION

• Enclosed cabs (with closed windows and filters) for airblast application.

• Re-entry - Do not allow entry into treated areas until spray has dried. If prior entry is necessary, wear cotton overalls buttoned to the neck and wrist (or equivalent clothing) and chemical resistant gloves. Clothing must be laundered after each day’s use.

Protection of Livestock

• DO NOT contaminate feed or foodstuffs with this product or empty containers.

Protection of Wildlife, Fish, Crustaceans and Environment

• Dangerous to fish. Do NOT contaminate streams, rivers, or watercourses with chemical or used containers.

Storage and Disposal

• Store in the closed, original container in a dry, cool well-ventilated area. Do not store for prolonged periods in direct sunlight.

• HDPE containers - Triple-rinse containers before disposal. Add rinsings to spray tank. Do not dispose of undiluted chemicals on site. If recycling, replace cap and return clean containers to the recycler or designated collection point.

• If not recycling, break, crush, or puncture and deliver empty packaging to an approved waste management facility. If an approved waste management facility is not available, bury the empty packaging 500 mm below the surface in a disposal pit specifically marked and set up for this purpose, clear of waterways, desirable vegetation, and tree roots, in compliance with relevant local, state, or territory government regulations. Do not burn empty containers or product.

• Plastic bag in cardboard container - Single-rinse or shake remainder into spray tank. Do not dispose of undiluted chemicals on site. Puncture and deliver empty packaging to an approved waste management facility. If an approved waste management facility is not available, bury the empty packaging 500 mm below the surface in a disposal pit specifically marked and set up for this purpose, clear of waterways, desirable vegetation, and tree roots, in compliance with relevant local, state, or territory government regulations. Do not burn empty containers or product.