Arvesta Select 120

Manufacturer
Arysta LifeScience
Category
Herbicides
Registered until
2024-06-30
Registration number
55933
Active materials
Links

For the control of certain grass weeds in beetroot, cabbage, canota, celery, chickpeas, cotton, faba beans, field peas, forestry, lettuce, lupins, mung beans, non-bearing fruit trees, onions, ornamentals, peanuts, potatoes and soybeans.

GENERAL INSTRUCTIONS


Clethodim is a member of the cyclohexanedione group of herbicides. Clethodim has the acetyl CoA carboxylase inhibitor mode of action. For weed resistance management, Arvesta Select 120 Herbicide is a Group A Herbicide. Some naturally occurring weed blotypes resistant to Arvesta Select 120 Herbicide and other Group A Herbicides may exist through normal genetic variability in any weed population. The resistant individuals can eventually dominate the weed population if these herbicides are used repeatedly. These resistant weeds will not be controlled by Arvesta Select 120 Herbicide or other Group A Herbicides.
Since the occurrence of resistant weeds is difficult to detect prior to use, Tomen Australia Ltd accepts no liability for any losses that may result from the failure of Arvesta Select 120 Herbicide to control resistant weeds.
strategies to minimize the risk of herbicide resistance are available. Contact your farm chemical supplier, consultant or local Department of Agriculture.

MIXING


To ensure even mixing, half-fill the spray tank with clean water and add the required amount of product, then add the remainder of the water. Agitate again before spraying commences.

APPLICATION


Ground Application: Arvesta Select 120 Herbicide should be applied with calibrated spray equipment producing a median droplet range of 200 to 300 microns VMD. Apply in a minimum of 50 Iitres of water per hectare. Use 150 Uha when spraying dense populations.

Aerial Application:


Arvesta Select 120 Herbicide can be applied through aircraft fitted with boom or Micronair equipment. A spray volume of 20 to 30 Uha is recommended and equipment should be adjusted to deliver droplets in the range of 200 to 250 microns VMD.
Best results will be obtained when aerial applications are made in a light crosswind. Applications should not be made during temperature inversions or in conditions of very low relative humidity. Care should be taken to avoid drift damage to adjoining grass crops.

COMPATIBILITY
Arvesta Select 120 Herbicide is compatible with the following grass herbicides: Tarqa, Fusilade, Verdict, Sertin and Correct. (Refer to the Bayer Correct label for detail on adjuvant recommendations for that product).
NOTE: In all situations where Arvesta Select 120 Herbicide is mixed with another grass herbicide, Arvesta Select 120 Herbicide should be used at the full label rate specified for the target weed species.
Arvesta Select 120 Herbicide may also be applied in tank mixtures with one of the following products: Sumi-Alpha' 50 EC, Sumi-Alpha' Dual, Fastac'100 and l.e-Mat".
Arvesta Select 120 Herbicide should not be applied in a tank mix with Broda!'. Apply as separate applications.
For information on compatibility of products not listed, please refer to Tomen Australia Ltd.

Registered for culturesRatePreharvest Interval
Canola300 - 750 ml56
Chickpeas300 - 750 ml
Beans300 - 750 ml
Peas300 - 750 ml
Lupines300 - 750 ml
Cotton500 - 750 ml84
Peanuts500 - 750 ml49
Mung beans500 - 750 ml
Soybeans500 - 750 ml
Red beet300 - 1000 ml7
Cabbage300 - 1000 ml7
Celery300 - 1000 ml63
Lettuce300 - 1000 ml28
Potatoes300 - 1000 ml28
Onions300 - 1000 ml14