Axistrobin 250 SCPlant Protection Product ComparisonPlant Protection Product ComparisonReport inaccuraciesReport inaccuracies

GENERAL INSTRUCTIONS

APPLICATION:

DO NOT use concentration factors exceeding 4x when applying through low volume application equipment, except when applying AC Axistrobin 250 SC Fungicide by air. In these cases, adequate coverage of all plant surfaces is still required to achieve control of diseases.

Tree Crops and Vines:

Dilute Spraying:

• • Use a sprayer designed for high water volumes up to the point of run-off, matched to the crop. Set up and operate for even coverage throughout the crop canopy.
  • Apply sufficient water to cover the crop to the point of run-off. Avoid excessive run-off.
  • Determine the required water volume based on industry guidelines or expert advice.
  • Add the specified amount of product for each 100 L of water. Spray to the point of run-off, adjusting as the crop grows.Concentrate Spraying:
    • Use a sprayer designed for concentrate spraying.
    • Set up for even coverage throughout the crop canopy.
    • Determine an appropriate dilute spray volume for the crop canopy to calculate the concentrate mixing rate.
    • Adjust spray volume, product amount, and sprayer setup as the crop grows.

MIXING:

• Half-fill the spray tank with clean water and start agitation.
• Shake the closed AC Axistrobin 250 SC Fungicide container.
• While filling the remainder of the spray tank, add the required amount of AC Axistrobin 250 SC Fungicide, adding any tank mix products last.
• Maintain agitation until spraying is complete. DO NOT leave the spray mix in the sprayer overnight.

COMPATIBILITY/TANK MIXING:

• AC Axistrobin 250 SC Fungicide may be mixed with Alphacypermethrin, Bifenthrin, Chlorothalonil, Captan, Copper Hydroxide, Dipel®, Lambda-cyhalothrin, Thiodicarb, Permethrin, and Procymidone.

TO AVOID CROP DAMAGE:

a. Riberries, Anise myrtle, and lemon myrtle are not known to be sensitive to this product when used according to label directions. Conduct small-scale testing before large-scale use.

b. Nursery stock, ornamentals, and cut flowers/foliage (other than certain apple varieties) are not known to be sensitive but conduct small-scale testing.

Re-entry:

Do not enter treated areas until the spray has dried, unless wearing cotton overalls buttoned to the neck and wrist. Clothing must be laundered after each day’s use.

EXPORT OF TREATED PRODUCE:

GRAPES: Check with your winery or the Australian Wine Research Institute for export tolerances.

OTHER CROPS: MRLs or import tolerances may not be established in all export destinations. Check with your export organization or Axichem Pty Limited representative.

PROTECTION OF WILDLIFE, FISH, CRUSTACEANS AND ENVIRONMENT:

Highly toxic to aquatic life. DO NOT contaminate dams, waterways, or drains. DO NOT apply under conditions causing spray drift on adjacent areas, especially wetlands, water bodies, or watercourses.

STORAGE AND DISPOSAL:

• Store in the closed, original container in a cool, well-ventilated area. DO NOT store for prolonged periods in direct sunlight.
• Triple or preferably pressure rinse containers before disposal. Add rinsings to the spray tank. DO NOT dispose of undiluted chemicals on-site.
• If recycling, replace the cap and return clean containers to the recycler. If not recycling, deliver empty packaging to an approved waste management facility.
• If no facility is available, bury the empty packaging 500mm below the surface in a designated pit. DO NOT burn empty containers or product.

SAFETY DIRECTIONS:

• Will irritate the eyes. Avoid contact with the eyes. Wash hands after use. When handling, wear cotton overalls buttoned to the neck and wrist. After each day’s use, wash gloves and contaminated clothing.