Bromo 400Plant Protection Product ComparisonPlant Protection Product ComparisonReport inaccuraciesReport inaccuracies

GENERAL INSTRUCTIONS

Before opening, carefully read Directions for Use, Precautionary and Protection Statements, Storage and Disposal, Safety Directions, and First Aid Instructions. Use only at recommended growth stages of crops and weeds. DO NOT use on crops other than recommended.

MIXING INFORMATION To ensure even mixing, half fill the spray tank with clean water and add the required amount of this product. Agitate thoroughly, then add the remainder of water. Agitate again before spraying commences.

APPLICATION BOOM SPRAYER USE ONLY low boom equipment set up to provide good coverage of weeds within the crop canopy. USE ONLY spray droplets not smaller than a COARSE spray droplet size category. Apply 50-200 L (WA: 50-100 L) of water per hectare. Calibrate the machine before use to ensure that the correct application rate is obtained. Check the height of the boom above the crop to ensure that the spray is evenly distributed. A minimum of 160 L and preferably 200 L of water per hectare is recommended where the weed infestation is heavy or the crop cover is dense.

AERIAL APPLICATION Apply a minimum of 22 L of water per hectare. Markers should always move upwind before the aircraft passes overhead. Application by micronaire equipment may give variable results.

EQUIPMENT MAINTENANCE After use, wash equipment thoroughly and rinse several times before re-use. Wash sprayer thoroughly with clean water after use. If using tank mixes with Conquest 2,4-D Amine 625 or Conquest MCPA Amine 750 apply with equipment that will not be used in 2,4-D and MCPA susceptible crops, particularly cotton and vines.

Resistance Warning Bromo 400 EC Selective Herbicide is a member of the nitriles group of herbicides. Bromo 400 has the photosystem II inhibitor mode of action. For weed resistance management, Bromo 400 is a Group 6 herbicide. Some naturally occurring weed biotypes resistant to Bromo 400 and other Group 6 herbicides may exist through normal genetic variability in any weed population. The resistant individuals can eventually dominate the weed population if these herbicides are used repeatedly. These resistant weeds will not be controlled by this product or other Group 6 herbicides. Since the occurrence of resistant weeds is difficult to detect prior to use, Conquest Crop Protection Pty. Ltd. accepts no liability for any losses that may result from the failure of Bromo 400 to control resistant weeds. However, resistance should not be assumed without first viewing the method of application, the coverage, and the timing of application.

Precautions Re-entry statements for the general public: DO NOT allow entry into treated areas until the spray has dried. Re-entry statements for occupational users: DO NOT enter treated areas until the spray has dried, unless wearing cotton overalls buttoned to the neck and wrist (or equivalent clothing) and chemical-resistant gloves. Clothing must be laundered after each day’s use.

Protections PROTECTION OF CROPS, NATIVE AND OTHER NON-TARGET PLANTS Drift Warning: DO NOT apply under weather conditions, or from spraying equipment, that may cause spray to drift onto nearby susceptible plants/crops, cropping lands, or pastures. Note: Maximum daily temperatures at or above 20°C at application, or on days following treatment may result in seedling mortality and established plants may be damaged. PROTECTION OF LIVESTOCK Low hazard to bees. May be applied at any time as recommended in the Directions for Use. PROTECTION OF WILDLIFE, FISH, CRUSTACEANS, AND ENVIRONMENT Dangerous to fish. DO NOT contaminate streams, rivers, or waterways with the chemical or used containers.

Storage and Disposal Non-refillable: Store in the closed, original container in a cool, well-ventilated area. DO NOT store for prolonged periods in direct sunlight. Protect from frost. Triple rinse containers before disposal. Add rinsings to the spray tank. DO NOT dispose of undiluted chemicals on site. If recycling, replace the cap and return clean containers to recycler or designated collection point. If not recycling, break, crush, or puncture and deliver empty packaging to an approved waste management facility. If an approved waste management facility is not available, bury the empty packaging 500 mm below the surface in a disposal pit specifically marked and set up for this purpose clear of waterways, desirable vegetation, and tree roots, in compliance with relevant Local, State, or Territory government regulations. DO NOT burn empty containers or product. Envirodrum Refillable containers: empty contents fully into application equipment. Close all valves and return to the point of supply for refill or storage. Store the original sealed container in a cool, well-ventilated area. DO NOT store for prolonged periods in direct sunlight. DO NOT tamper with the Micro Matic valve or the security seal. DO NOT contaminate the container with water or any foreign matter. After each use of the product, please ensure that the Micro Matic coupler, delivery system, and hoses are disconnected, triple rinsed with clean water, and drained accordingly. When the contents of the container have been used, please return the container to the point of purchase. Other refillable containers: Store in the closed, original container in a cool, well-ventilated area. DO NOT store for prolonged periods in direct sunlight. Storage must be secure so that contents cannot be tampered with. All locks and/or seals must be in order. If locks or seals are broken prior to initial use then the integrity of this product cannot be assured. If this occurs, Conquest Crop Protection should be advised immediately. DO NOT rinse empty container. Empty contents fully into application equipment. Close all valves and return to the point of supply for refill or storage. No other liquid, solid, or pesticide product should be put into it.