Buctril 200 ECPlant Protection Product ComparisonPlant Protection Product ComparisonReport inaccuraciesReport inaccuracies

GENERAL INSTRUCTIONS

Before opening, carefully read Directions for Use, Precautionary and Protection Statements, Storage & Disposal, Safety Directions, and First Aid Instructions. Use only at recommended growth stages of crops and weeds. Do not use on crops other than recommended.

Mixing information: To ensure even mixing, half fill spray tank with clean water and add the required amount of this product. Agitate thoroughly, then add the remainder of the water. Agitate again before spraying commences.

Boom sprayer: Apply 50 to 200 (WA 50 to 100 Litres) litres of water per hectare. Calibrate the machine before use to ensure that the correct application rate is obtained. Check height of boom above the crop to ensure that the spray is evenly distributed. A minimum of 160 litres and preferably 200 litres of water per hectare is recommended where the weed infestation is heavy or the crop cover is dense. DO NOT use raindrop or air induction nozzles as coverage of weeds may not be accurate.

Aerial application: Apply a minimum of 22 litres of water per hectare. Markers should always move upwind before aircraft passes overhead. Application by micronair equipment may give variable results.

Equipment maintenance: After use, wash equipment thoroughly and rinse several times prior to re-use. Wash sprayer thoroughly with clean water after use. If using tank mixtures with 2,4-D Amine or MCPA 500 apply with equipment that will not be used in 2,4-D and MCPA susceptible crops, particularly cotton and vines.

Compatibility: This product may be mixed in the spray tank with one of the following herbicides & insecticides in wheat and barley only: Diclofop Methyl Selective Herbicide, Omethoate, Chlorpyrifos, Dimethoate, 2,4-D Amine, MCPA 500 Chlorsulfuron, Metsulfuron-Methyl, Diflufenican, Glyphosate, Propaquizafop, and Dicamba.

FUNGICIDE RESISTANCE WARNING: Buctril 200 EC Herbicide is a member of the nitrile group of herbicides. The product has the inhibitors of photosynthesis at photosystem II mode of action. For weed resistance management, the product is a Group 6 herbicide. Some naturally occurring weed biotypes resistant to the product and other Group 6 herbicides may exist through normal genetic variability in any weed population. The resistant individuals can eventually dominate the weed population if these herbicides are used repeatedly. These resistant weeds will not be controlled by the product or other Group 6 herbicides. Since the occurrence of resistance weeds is difficult to detect prior to use, Bayer CropScience Pty Ltd accepts no liability for any losses that may result from the failure of this product to control resistant weeds.

PROTECTION OF CROPS, NATIVE AND OTHER NON-TARGET PLANTS: DO NOT apply under weather conditions, or from spraying equipment, that may cause spray to drift onto nearby susceptible plants/crops, cropping lands, or pastures. Note: Maximum daily temperatures at or above 20 °C at application, or on days following treatment may result in seedling mortality and established plants may be damaged.

PROTECTION OF LIVESTOCK: Low hazard to bees. May be applied at any time as recommended in the Directions for Use.

PROTECTION OF WILDLIFE, FISH, CRUSTACEAN AND THE ENVIRONMENT: Dangerous to fish. Do not contaminate streams, rivers, or waterways with the chemical or used containers.

STORAGE AND DISPOSAL: Store in the closed, original container in a cool, well-ventilated area. DO NOT store for prolonged periods in direct sunlight. (Drummuster/not re-usable packs) Triple rinse containers before disposal. Add rinsings to spray tank. DO NOT dispose of undiluted chemicals on site. If recycling, replace caps and return clean containers to recycler or designated collection point. If not recycling, break, crush, or puncture and deliver empty packaging to an approved waste management facility. If an approved waste management facility is not available, bury the empty packaging 500 mm below the surface in a disposal pit specifically marked and set up for this purpose, clear of waterways, desirable vegetation, and tree roots, in compliance with relevant Local, State or Territory government regulations. DO NOT burn empty containers or product. Do not re-use empty containers for any other purpose. (Schutz/returnable/re-usable packs) If tamper evident seals are broken prior to initial use then the integrity of the contents cannot be assured. Empty container fully into application equipment by pumping through the dry-break connection system. Do not attempt to unscrew the valve or breach the locked filling point. Do not contaminate the container with water or other foreign material. Ensure that the coupler, pump, meter and hoses are disconnected, triple rinsed with clean water and drained after each use. Contact point of purchase to arrange return or collection of empty containers. This container remains the property of Bayer CropScience Pty Ltd. (1000 L) If tamper evident seals are broken prior to initial use then the integrity of the contents cannot be assured. Empty product fully into application equipment. Do not attempt to breach the valve system or filling point, or contaminate the container with water or other products. Ensure that equipment used in transfer of the product is disconnected, triple rinsed with clean water and drained after each use. When the container is empty, close all caps and valves and return the container to the point of purchase. Do not re-use empty container for any other purpose.