Flume 800WGPlant Protection Product ComparisonPlant Protection Product ComparisonReport inaccuraciesReport inaccuracies

Mixing:

Quarter-fill the spray tank and add the required amount of Flume 800WG Herbicide. Add the remaining water with the agitator running. Add Uptake Spraying Oil or the wetting agent last (if used). Maintain agitation during spraying. Only mix sufficient spray solution for immediate use and avoid storing.

When tank mixing, Flume 800WG Herbicide should be added to the tank first, followed by wettable powders or other dry flowable formulations, suspension concentrates (flowables), aqueous concentrates (e.g. Lontrel Herbicide), emulsifiable concentrates (e.g. Verdict 520 Herbicide), and then add Uptake Spraying Oil or wetting agent last (if used).

Application:

Apply Flume 800WG Herbicide in 50 to 150 liters of water per hectare, through an accurately calibrated boom sprayer. For aircraft application, apply Flume 800WG Herbicide in no less than 30 L/ha of water through accurately calibrated equipment. The product should be applied by an accurately calibrated ground rig or aircraft delivering medium quality spray based on the BCPC specifications and in accordance with ASAE Standard S-572. Best results are achieved where applications are made on warm (greater than 5°C), sunny days applying more than 50L/ha of total spray volume (preferably more than 75 L/ha) and where spray coverage is maximized.

Compatibility:

Always allow 7 days between application of a grass herbicide and Flume 800WG Herbicide in chickpeas and field peas. In lentils, adjuvant, broadleaf or grass herbicide, insecticide and foliar fertilizer tank mixes may result in transient height reduction, crop discoloration, and delayed flowering, although yields are normally unaffected. However, stress conditions after application (e.g. frost, drought) may lengthen the time needed for lentils to recover and in years where a dry spring occurs, yields may be suppressed.

Cleaning Spray Equipment:

After using Flume 800WG Herbicide, empty the tank completely and drain the whole system. Thoroughly wash inside the tank using a pressure hose. Drain the tank and clean any filters in the tank, pump, lines, and nozzles.

To rinse, after cleaning the tank as above, quarter fill the tank with clean water and circulate through the pump, lines, hoses, and nozzles. Drain and repeat the rinsing procedure twice.