Fluroken 333
- Manufacturer
- Kenso Corporation
- Category
- Herbicides
- Registered until
- 2025-06-29
- Registration number
- 65644
- Active materials
GENERAL INSTRUCTIONS
MIXING:
- Fluroken 333 can be mixed with water or diesel.
- Mix only the amount needed for each day; avoid storing mixed solutions.
Mixing in Water:
- Half fill the spray tank with water.
- Add Fluroken 333 and complete filling, agitating continuously for thorough mixing.
Mixing in Diesel:
- Half fill the spray tank with diesel.
- Add Fluroken 333 and remaining diesel; agitate or shake to mix.
Tank Mixtures:
- Add wettable powder or dry flowable formulations first, followed by suspension concentrates, water-soluble salts, and emulsifiable concentrate formulations (Fluroken 333).
- Add spraying oils and surfactants last.
OILS AND SURFACTANTS:
- Oils: Use Uptake Spraying Oil at specified rates.
- Surfactants (Wetters): Use non-ionic surfactants like Ken-Wett 1000 where required.
APPLICATION METHODS AND WATER RATES
BROADCAST APPLICATION IN CROPPING, PASTURE, AND FALLOW SITUATIONS:
A. Ground Application (Boom):
- Apply with a calibrated boom sprayer in at least 50 L/ha water (100-400 L/ha for sugar cane).
- Use flat fan nozzles at 200-300 kPa pressure.
- Set the boom at a height for double overlap of nozzle patterns.
B. Ground Directed Application (Dropper Nozzles):
- Use dropper nozzles in sorghum (beyond 8 leaf growth stage), maize, and sweet corn (beyond 6 leaf growth stage).
- Adjust nozzles to direct spray into the base of the crop.
C. Aerial Application:
- Apply in a minimum volume of 35 L/ha water (60 L/ha in sugarcane).
- Use calibrated equipment producing droplets with VMD of 250-350 microns.
- Avoid application in high temperatures, no wind, or wind toward susceptible crops.
WOODY WEED SITUATIONS:
- Weeds must be actively growing.
- Delay treatment of regrowth until at least 1 meter of new growth.
A. High Volume Application (Hand Gun, Knapsack):
- Apply recommended mix for full coverage.
- Use a spray volume of 1500 to 4000 L/ha for thorough coverage.
B. Low Volume, High Concentrate Application (Drench Gun or Gas-Powered Gun):
- Apply uniformly across foliage by applying 50 mL shots.
C. Basal Bark and Cut Stump Application:
Basal Bark:
- Spray or paint recommended mixture around the base of each stem.
Cut Stump:
- Apply liberally to freshly cut stump immediately after cutting.
CLEANING SPRAY EQUIPMENT:
Rinsing (Water-Based Sprays):
- Thoroughly wash inside the spray unit using a pressure hose.
- Rinse with clean water.
Decontamination (Before Spraying Cotton and Other Sensitive Crops):
- Wash with an alkali detergent for at least 15 minutes.
Cleaning (Diesel-Based Sprays):
- Use a degreaser to remove diesel traces.
- Rinse tank and spray through nozzles with water.
- Clean brushes and containers with degreaser and detergent.
Note: Always refer to the latest local regulations and guidelines, and consult with local experts for crop-specific advice.