Glyphosate 450 K-SaltPlant Protection Product ComparisonPlant Protection Product ComparisonReport inaccuraciesReport inaccuracies

ACCENSI Glyphosate 450 K-Salt Herbicide is a non-volatile, non selective, water soluble liquid herbicide for the control of annual and perennial grasses and broadleaf weeds in a wide range of agricultural and non-agricultural use situations. AGGENSI Glyphosate 450 K-Salt Herbicide may be used for weed control on agricultural land prior to sowing anY edible or non-edible crop but not prior to transplanting tomato seedlings. When applying this product prior to transplanting crops into plastic mulch, care must be taken to remove residues of this product from the plastic prior to transplanting. Residues can be removed by 2 em of natural rainfall or by applying water via a sprinkler irrigation system. ·
ACCENSI GlyphosatB 450 K-Salt Herbicide is absorbed by plant foliage and green stems.lt is inactivated in the soil and does not provide residual weed corrtrol. ACCENSI Glyphosate 450 K-Salt Herbicide moves through the plant from the point of contact to and into the root system.lnitial visible effects on annual weeds take 3-7 days but may not be noticeable for 2 to 3 weeks under cool doudy conditions or on some perennial weeds.

APPLICATION

Boom Equipment
For boom application, a spray volume of BD L/ha or less is re~;ommended for optimum performanGe. Nozzles and pressure settings should be selected to deliver a MEDIUM or MEDIUM-COARSE size droplet at the target (BCPC- British Crop Protection Council standard). The use of nozzles and/or pressure settings that produce VERY FINE or FINE droplets should be avoided as these are prone to Joss or drift. In muftiple product tank. mixes, a minimum water volume of 50 LJha is reoommended and local advice should be sought. Correct mixing order is importallt as is goOd in-tank. agitation when application iS occurring.
For shielded applications a spray volume of 80 Usprayed ha is re~;ommended using nozzle types and pressure settings to deliver a COARSE (BCPC) size droplet at the target.
Crop damage may result if spray drtft oGcurs 1hrough incorreGt nozzle and/or pressure selection, inadequate shielding and/or wind strength, high evaporation rates or excessive ground speed.

Wiper Equipment
Wiper equipment (e.g. RopewiGk, canvas, felt or carpet applicators) may be use[J to apply ACCENSI Glyphosate 450 K-Salt Herbicide. Avoid contact with desirable vegetation.
Operate wiper equipment a minimum of 10 em above the crop or pasture. Weeds should be at least 15 Gm above the crop or pasture at time of application. Speed of travel should be no greater than 8 kin/h. Best results are achieved at lower speeds and where two appliGations are made in opposite directions (double pass). Where weeds a're of variable height, or occur in dense infestations or clumps, some plants may not be contacted by the herbiGide solution. In these cases repeat treatment-may be neGessary.

RATE: Mix B40 mL ACCENSI Glyphosate 450 K-Salt Herbicide with 2.31itres clean water. Adjust flow rate to suit equipment.

Aerial Equipment
ACCENSI Glyphosate 450 K-Salt HerbiGide may be applied by aircraft for control of weeds in forests, cropland or pasture prior to establishment of crops, new pastures or new forest plantings and for pre-harvest applications to sorghum and Gorton crops up to a maximum rate o12.7 Uha where spe~;ified by this label. DD NOT apply treatments by aircraft in situations where drift onto se11sitive crops and pastures is likely to occur.
Apply treatments using boom or Micronair equipment using a spray volume not less than 20 Uha and using settings to produce a mediall droplet diaineter of 250 350 microns.
Swath width should be set to take into account ain:raft type, wind GOnditions and target height. Swath width will need to be reduced to avoid stripping under light willd conditions and/or application to tall, dense targets e.g. pre-harvest application, treatments in heavy crop stubble. Thoroughly wash aircraft, espe~;ially landing gear, after each day of spraying to remove herbicide residues.

Application on hilly terrain
lnnease water volume to 30-80 Uha and in~;rease droplet diameter of output to at least 300 microns to optimise deposition of spray output onto weeds.