Iconix 500 ECPlant Protection Product ComparisonPlant Protection Product ComparisonReport inaccuraciesReport inaccuracies

GENERAL INSTRUCTIONS

MIXING

To ensure even mixing, half fill the spray tank with clean water, add the required amount of product, and stir thoroughly. Add the remainder of the water and mix again before spraying.

APPLICATION

The use of this product should follow standard pre-emergence herbicide treatments or cultivation; otherwise, the weeds are likely to be too large for successful treatment by the time the onions have reached the tolerant stage.

DO NOT apply on a windy day. DO NOT apply by aircraft or misting machine.

Boom Sprayer

Equip the machine with flat-fan nozzle tips designed to apply 440 or more liters of water per hectare at a pressure of 200 to 280 kPa. Calibrate the machine before use to ensure that the correct application rate is obtained. Check the height of the boom to ensure that the spray is evenly distributed.

COMPATIBILITY

As formulations of other manufacturers’ products are beyond the control of Imtrade Australia Pty Ltd, all mixtures should be tested prior to mixing commercial quantities.

RESISTANCE WEED WARNING

Imtrade Iconix® 500 EC Herbicide is a member of the nitrile group of herbicides and has the inhibitor of photosynthesis at photosystem II mode of action. For weed resistance management, this is a Group 6 Herbicide. Some naturally occurring weed biotypes resistant to Imtrade Iconix® 500 EC Herbicide and other Group 6 Herbicides may exist through normal genetic variability in any weed population. The resistant individuals can eventually dominate the weed population if these herbicides are used repeatedly. These resistant weeds will not be controlled by Imtrade Iconix® 500 EC Herbicide or other Group 6 Herbicides.

Since the occurrence of resistant weeds is difficult to detect prior to use, Imtrade Australia Pty Ltd accepts no liability for any losses that may result from the failure of Imtrade Iconix® 500 EC Herbicide to control the resistant weeds.

GROUP 6 HERBICIDE

PRECAUTIONS

RE-ENTRY

• DO NOT enter treated areas until the spray has dried unless wearing cotton overalls buttoned to the neck and wrist (or equivalent clothing) and chemical-resistant gloves. Clothing must be laundered after each day’s use.

• DO NOT undertake thinning plants for 8 days, hand harvesting and scouting for 22 days, hand set irrigation for 25 days, and hand weeding > 30 days post-treatment unless wearing cotton overalls buttoned to the neck and wrist (or equivalent clothing) and chemical-resistant gloves. Clothing must be laundered after each day’s use.

PROTECTION OF WILDLIFE, FISH, CRUSTACEANS, AND ENVIRONMENT

• DO NOT contaminate streams, rivers, or waterways with Imtrade Iconix 500 EC Herbicide or used containers.

PROTECTION OF CROPS, NATIVE AND OTHER NON-TARGET PLANTS

• DO NOT apply under weather conditions, or from spraying equipment, that may cause spray to drift onto nearby susceptible plants/crops, cropping lands, or pastures.

STORAGE AND DISPOSAL

The method of disposal of the container depends on the container type. Read the Storage and Disposal instructions on the label that is attached to the container.

SAFETY DIRECTIONS

• Poisonous if swallowed. Harmful if inhaled. May irritate the skin. Will irritate the eyes. Repeated exposure may cause allergic disorders. Avoid contact with eyes and skin. DO NOT inhale spray mist. When opening the container, preparing spray and using the product by boomspray equipment (open cab), wear cotton overalls buttoned to the neck and wrist (or equivalent clothing), elbow-length chemical-resistant gloves, and face shield or goggles. Wash hands after use. After each day’s use, wash gloves, face shield, goggles, and contaminated clothing.