GENERAL INSTRUCTIONS
USE OF WETTING AGENT
When diluting with water, add a non-ionic surfactant at registered label rates.

SPRAY PREPARATION
Quarter to half fill spray tank with water. Start agitation (do NOT use air agitation). Add the required amount of this product to the tank and complete filling with water. Add a non-ionic surfactant as recommended above. Continue agitation for several minutes prior to spraying to fully mix the chemical.

APPLICATION
a) Larvicidal: Apply at the recommended rates when the infestation reaches an economically damaging level and repeat as needed. Apply the lower rates on small larvae and on light infestations of insects. Use the higher rate on large larvae and heavier infestations of insects. Best control is obtained when young insects are treated.

b) Ovidical/Larvicidal: Use these rates only where crops are regularly monitored for eggs and larvae. Use the lower rate when only eggs are present. Use the higher rate when heavy egg lays occur and/or when larvae are less than 3 mm long. If larvae are longer than 3 mm, use the larvicidal rates. This product may be used at ovicidal/larvicidal rates in conjunction with other recommended larvicides used to control other insects.