Sparc

Manufacturer
Farmalinx
Category
Fungicides
Registered until
2024-06-29
Registration number
84773
Active materials
Links

GENERAL INSTRUCTIONS

Fungicide Resistance Warning

Farmalinx SPARC Fungicide is a member of the multi-site activity group of fungicides. For fungicide resistance management, the product is a Group M9 fungicide. Some naturally occurring individual fungi resistant to Farmalinx SPARC Fungicide and other Group M9 fungicides may exist through normal genetic variability in any fungal population. The resistant individuals can eventually dominate the fungal population if these fungicides are used repeatedly. These resistant fungi will not be controlled by Farmalinx SPARC Fungicide or other Group M9 fungicides, thus resulting in a reduction in efficacy and possible yield loss. Since the occurrence of resistant fungi is difficult to detect prior to use, Farmalinx Pty Ltd accepts no liability for any losses that may result from the failure of Farmalinx SPARC Fungicide to control resistant fungi.

MIXING

With the agitation system operating, pour the measured volume of Farmalinx SPARC Fungicide slowly into the required volume of water in the spray vat. Mix thoroughly and then add any other compatible spray materials. Sprays containing Farmalinx SPARC Fungicide should be used within 3 hours of preparation and they should be agitated continuously during this period.

WETTING AGENTS

A wetting agent is not required for Farmalinx SPARC Fungicide, however one may be added if required for other pesticides, provided it is non-ionic.

APPLICATION

Dilute Spraying

  • Use a sprayer designed to apply high spray volumes, up to the point of run-off and matched to the crop being sprayed.

  • Set up and operate the sprayer to achieve even coverage throughout the crop canopy. Apply sufficient spray solution to cover the crop to the point of run-off. Avoid excessive run-off.

  • The required spray volume to achieve point of run-off may be determined by applying different test volumes, using different settings on the sprayer, or from industry guidelines or other expert advice.

  • Add the amount of product specified in the Directions for Use Table for each 100 L of water. Spray to the point of run-off.

  • The required dilute spray volume to achieve point of run-off will change and the sprayer set up and operation may also need to be changed, as the crop grows.

Concentrate Spraying

  • Use a sprayer designed and set up for concentrate spraying (that is a sprayer which applies spray volumes less than those required to reach the point of runoff) and matched to the crop being sprayed.

  • Set up and operate the sprayer to achieve even coverage throughout the crop canopy using your chosen spray volume.

  • Determine an appropriate dilute spray volume (See Dilute Spraying above) for the crop canopy. This is needed to calculate the concentrate mixing rate.

  • The mixing rate for concentrate spraying can then be calculated in the following way:

    • Example Only

      1. Dilute spray volume as determined above: For example 1500 L/ha

      2. Your chosen concentrate spray volume: For example 500 L/ha

      3. The concentration factor in this example is: 3 X (i.e. 1500 L ÷ 500 L = 3)

      4. If the dilute label rate is 20 mL/100 L, then the concentrate rate becomes 3 x 20 (that is 60 mL of product per 100 L water for concentrate spraying).

  • The chosen spray volume, amount of product per 100 L of water, and the sprayer set up and operation may need to be changed as the crop grows.

For further information on concentrate spraying, users are advised to consult relevant industry guidelines, undertake appropriate competency training and follow industry Best Practices.

COMPATIBILITY

Farmalinx SPARC Fungicide is compatible with any one of the following: Bogard+ 100 WG, chlorpyrifos WP, Pirate(methomyl), Systhane+ WP, Topas+ 100 EC, TORQUE®, and wettable sulphur. Farmalinx SPARC Fungicide should NOT be mixed with more than one other material, other than non-ionic wetting agent. Farmalinx SPARC Fungicide is incompatible with Agridex+, chlorpyrifos EC, and winter or summer oils. It is also incompatible with alkaline materials such as lime Sulphur and lime. Under certain conditions, it is incompatible with spraying oils and some other liquid formulations (see below).

Spraying Oils: Farmalinx SPARC Fungicide should only be applied with Winter or Summer oils at the dormant or bud burst stages. At other times it should not be applied with these materials or before or after oil cover sprays.

Liquid Formulations: Farmalinx SPARC Fungicide should not be applied to pome fruit mixed with liquid formulations liable to cause ring spot.

CROP SAFETY

If climatic conditions at the time of application result in slow drying of the spray deposit, some varieties of fruit may show minor skin russeting.

PROTECTION OF WILDLIFE, FISH, CRUSTACEANS AND ENVIRONMENT

Dangerous to fish. DO NOT contaminate streams, rivers or waterways with the chemical or used container.

STORAGE AND DISPOSAL

Store in the closed, original container, in a dry, cool, well-ventilated area out of direct sunlight. Single rinse before disposal. Add rinsings to spray tank. Do not dispose of undiluted chemicals on site. Puncture and deliver empty packaging to an approved waste management facility. If an approved waste management facility is not available bury empty packaging below 500mm below the surface in a disposal pit specifically marked and set up for this purpose clear of waterways, desirable vegetation and tree roots, in compliance with relevant Local, State or Territory government regulations. Do not burn empty containers or product.

SAFETY DIRECTIONS

Poisonous if swallowed. Harmful if inhaled. Will damage the eyes. Will irritate the skin. Avoid contact with eyes and skin. Do NOT inhale dust. Repeated exposure may cause allergic disorders. When opening the container and preparing spray, wear cotton overalls buttoned to the neck and wrist and a washable hat, elbow-length PVC gloves, and either a half face piece respirator with dust cartridge or canister and goggles or a full face piece respirator with dust cartridge or canister. When using the prepared spray, wear cotton overalls buttoned to the neck and wrist and a washable hat and elbow-length PVC gloves. If product on skin, immediately wash area with soap and water. If product in eyes, wash it out immediately with water. After use and before eating, drinking or smoking, wash hands, arms and face thoroughly with soap and water. After each day’s use wash gloves, goggles and contaminated clothing. Human flaggers must be protected by mechanical means such as enclosed vehicle cabs.


Registered for cultures
Pears
Apples