Tynomate SEPlant Protection Product ComparisonPlant Protection Product ComparisonReport inaccuraciesReport inaccuracies

GENERAL INSTRUCTIONS

Tynomate Application Methods:

Tynomate may be applied in a mix with liquid or coated onto granular fertilizer, or alone in an in-furrow liquid band, or as a combined in-furrow and surface band. It should be used in combination with a registered seed treatment for control of seedborne diseases such as smuts and bunts, e.g., Vibrance.

In-Furrow Application:

Granule Fertilizer: Ensure treated fertilizer is dry before sowing. Treated fertilizer should be sown in the same furrow as the seed, not broadcast. Note that the flow rate of fertilizer may be changed after treatment, and the seeder should be calibrated with the treated material to ensure that the correct rates of fertilizer and fungicide are delivered. Do not mix seed with treated fertilizer prior to planting. Once fertilizer has been treated, protect it from direct sunlight, exposure to water, and extreme environmental conditions prior to planting. Treated fertilizer should not be kept for extended periods of time.

Liquid: Tynomate can be used on seeding equipment by liquid banding below or beside the seed. It can be mixed with water or some (e.g., UAN) liquid fertilizers; agitation should be maintained. Tynomate is generally not compatible with liquid fertilizers containing phosphorus or sulfur (e.g., DAP liquids). Consult your local Conquest representative for compatibility of Tynomate and liquid fertilizers. Ensure there is a separation between the seed and liquid band, using the minimum distance recommended with the fertilizer. When applying Tynomate diluted in water, use a minimal separation distance of 15mm. When applying Tynomate as an in-furrow band, use a total solution volume of 20-100 L/ha at planting. When injecting Tynomate with liquid fertilizers, it is advised to use no more than 100 liters per hectare to avoid seedling damage.

Split Application:

Liquid In-Furrow and Surface Banding: Tynomate can be applied as a split in-furrow band (150 or 200 mL/ha) and surface band (150 or 200 mL/ha). With liquid in-furrow application, ensure there is separation between the seed and liquid band, using a total volume of 50-100 L/ha at planting. As a surface band, apply with water using a nozzle directed over the furrow, i.e., inside the plant row in a total volume of 50 - 100 L/ha. The maximum amount of Tynomate to be applied per hectare is 400 mL. Ensure that there is a minimal separation distance of 15mm between where the seed is planted and the surface banded application. The maximum band width of surface band should be 10cm.

Compatibility:

Check compatibility prior to use; contact your local Conquest representative for further information.

Mixing:

Half fill the spray tank with clean water and start agitation. Agitate the closed Tynomate container prior to use. While filling the remainder of the spray tank, add the required amount of Tynomate, adding