Converge 75 WDG

Manufacturer
BAYER
Category
Herbicides
Registered until
2027-12-31
Registration number
26142
Active materials
Links

FOR SALE FOR USE USE IN EASTERN CANADA AND BRITISH COLUMBIA ONLY
FOR USE IN FIELD CORN

GENERAL APPLICATION INFORMATION:
CONVERGE 75 WDG Herbicide is a water dispersible granule formulation of isoxaflutole at a concentration of 75% active ingredient. CONVERGE 75 WDG Herbicide is a selective herbicide for season long control of important broadleaf and grass weeds infesting field corn.
Surface Preplant: CONVERGE 75 WDG Herbicide can be applied to the soil surface up to 14 days prior to planting. CONVERGE 75 WDG Herbicide must be tankmixed with atrazine when applied surface preplant. If weed growth is present at the time of application, Roundup Original, Roundup Transorb, Roundup Weathermax, Roundup Ultra, Touchdown IQ, Vantage, Vantage Plus or Vantage Plus Max can be added to the CONVERGE 75 WDG Herbicide + atrazine treatment for burndown control of these weeds. Do not incorporate CONVERGE 75 WDG Herbicide.
Preemergence: CONVERGE 75 WDG Herbicide can also be applied after planting to just prior to crop emergence. Atrazine and/or Roundup Original, Roundup Transorb, Roundup Weathermax, Roundup Ultra, Touchdown IQ, Vantage, Vantage Plus or Vantage Plus Max can be tankmixed with preemergent applications of CONVERGE 75 WDG Herbicide.
When activated by rainfall, CONVERGE 75 WDG Herbicide will control susceptible weed seedlings that are up to 5 cm in height. Shallow tillage may be necessary to control weeds beyond this stage.

SPECIAL PRECAUTIONS:
Under certain conditions, temporary yellowing of some corn leaves may occur when the plant is in the seedling stage. These conditions include cold weather, excessive moisture and/or compacted soils. The symptoms are most visible where excessive rates have been applied, such as sprayer overlaps. The crop typically recovers quickly. Plant corn at least 4 cm deep. Failure to close the seed furrow may allow herbicide spray to directly contact the seed which can cause injury. If drought conditions persist after either a pre-plant surface or preemergent application, weed control, especially annual grass control, may be reduced.
DO NOT apply CONVERGE 75 WDG Herbicide to field corn grown on loamy sands or sands and/or soils with less than 2 % O.M.
DO NOT use on sweet or seed corn.
DO NOT graze or feed the treated immature corn to livestock prior to 60 days after application of CONVERGE 75 WDG Herbicide.

DIRECTIONS FOR USE:
MIXING INSTRUCTIONS:
Fill spray tank with 1/4 to 1/2 of the required volume of water prior to the addition of CONVERGE 75 WDG Herbicide. Add CONVERGE 75 WDG Herbicide slowly to the tank and agitate. If CONVERGE 75 WDG Herbicide is applied in tank-mixtures with other pesticides, add CONVERGE 75 WDG Herbicide to the spray tank first and ensure that it is thoroughly dispersed before continuing to fill the spray tank and adding other pesticides. Continue to fill the tank with water to the desired volume while agitating. Continue agitation when applying to ensure a uniform spray mixture.
Application with water or nitrogen solution as a diluent carrier: Nitrogen solution (28-0-0) may replace all or part of the water as a carrier. Check for compatibility by combining all ingredients in a small container in the same ratio as the anticipated use. If any indications of physical incompatibility develop, do not use this mixture for spraying. Indications of incompatibility usually will appear 5-15 minutes after mixing.

APPLICATION PROCEDURES:
Apply CONVERGE 75 WDG Herbicide in conventional, minimum tillage, or zero tillage crop management systems up to 14 days prior to planting, or after planting but before weeds or crop emerge. DO NOT apply after the corn emerges or crop injury may occur.
Apply CONVERGE 75 WDG Herbicide alone or in tank-mixtures, by ground equipment only, in a minimum of 200 litres of water per hectare at a spray pressure of 138-275 kPa. For best results use flat fan nozzles or comparable nozzles to achieve uniform spray distribution. DO NOT apply with hollow cone nozzles or with other application equipment which does not provide uniform coverage.
DO NOT APPLY BY AIR.

Registered for culturesRatePreharvest Interval
Corn105 - 140 g60