Elevate 50 WDGPlant Protection Product ComparisonPlant Protection Product ComparisonReport inaccuraciesReport inaccuracies

DIRECTIONS FOR USE
GENERAL INFORMATION
ELEVATE 50 WDG Fungicide is a cyclohexanecarboxamide protectant fungicide used for the control of Gray mold, Botrytis cinerea, on blackberries, bushberries (blueberry, currant, elderberry, gooseberry and huckleberry), ginseng, grapes, loganberries, raspberries (red and black) and strawberries. ELEVATE 50 WDG also controls diseases caused by Monilinia spp. on cherries, peaches and nectarines. This product should be used in a program with other products to provide season-long protection. Apply as a spray with ground equipment using sufficient water to obtain thorough coverage of plants. Dense foliage, thick mulch or excessive growth will often prevent adequate coverage; adjust spray volumes accordingly. Do not replant food crops, other than those for which the product is labelled, within 30 days following the last application.

MIXING DIRECTIONS
Begin with clean equipment. Prepare only the amount of solution needed to treat the determined area or the area that may be treated in a reasonable time. Add sufficient clean water to the spray tank for one-half of the mix load. Start tank agitation. Agitate to ensure thorough mixing while adding the appropriate amount of ELEVATE 50 WDG Fungicide and remaining required water. This product should be properly suspended and diluted prior to the addition of AGRAL 90 in grapes. Maintain agitation during mixing and application. DO NOT allow the spray mixture to stand without agitation. Apply with properly calibrated spray equipment. If agitation is stopped for any reason, the spray solution must be thoroughly re-mixed prior to any further use.

STORAGE
May be stored at ambient temperature. Keep in original container. This product should not be stored under extreme temperatures. To close package, make sure the package is folded to form an airtight seal and store under dry conditions. Insecticides and fungicides should be segregated from herbicides to prevent the possibility of  cross-contamination.

SPILL HANDLING
Clean up spill immediately. Place product and any contaminated cleanup materials in a chemical waste container. Wash contaminated area with soap and water. Pick up wash liquid with additional absorbent and place in a disposable container.

DISPOSAL
Follow provincial instructions for any required additional cleaning of the container prior to its disposal. Make the empty container unsuitable for further use. Dispose of the container in accordance with provincial requirements. For information on the disposal of the unused, unwanted product contact the manufacturer or the provincial regulatory agency. Contact the manufacturer and the provincial regulatory agency in case of a spill and for clean up of spills.