Fulfill 50WG

Manufacturer
SYNGENTA
Category
Insecticides
Registered until
2024-05-06
Registration number
27274
Active materials
Links

For control of aphids in leafy vegetables, aphids, including green peach, potato, buckthorn and foxglove aphids in potatoes and listed aphids in blueberries.

STORAGE
Store in a cool, dry, place away from food, drinks, and animal feeding stuffs. Keep in the original container tightly closed.

DECONTAMINATION AND DISPOSAL
For information on disposal of unused, unwanted product, contact the manufacturer or the provincial regulatory agency. Contact the manufacturer and the provincial regulatory agency in case of a spill, and for clean-up of spills.

GENERAL INFORMATION
FULFILL 50WG Insecticide is an insecticide for the control of aphids in potatoes. Apply FULFILL 50WG Insecticide to plant foliage when aphids first appear, before populations build to damaging levels. Consult Provincial guidelines and/or local extension experts. Thorough spray coverage is essential for best performance. Apply FULFILL 50WG Insecticide in sufficient water to ensure good coverage of all plant surfaces. The use of greater water volumes will generally result in better coverage, especially under adverse conditions (e.g., hot, dry) or where a dense plant canopy exists. See the Recommended Applications section of this label for specific recommendation on spray volumes.
FULFILL 50WG Insecticide exhibits excellent translaminar movement (movement across the leaf surface and into plant tissue) and is rainfast as soon as the spray solution has dried.

Mode of Action
FULFILL 50WG Insecticide works primarily by ingestion, but also has some contact activity. Affected aphids stop feeding shortly after exposure, but may remain on the plant foliage until they die, which is usually within 2-4 days. FULFILL 50WG Insecticide has residual activity in the plant and will control aphids that move onto the plant after spraying.

Suitability for Integrated Pest Management Programs
FULFILL 50WG Insecticide is suitable for Integrated Pest Management (IPM) programs as it has a low toxicity to beneficial insects (including honeybees and bumblebees) and mites. However, do not apply FULFILL 50WG Insecticide directly to the bees that are actively foraging in the field. Do not apply when flowering weeds are present.

Phytotoxicity
FULFILL 50WG Insecticide has been tested for phytotoxicity at the label rates and has shown no effects on the varieties of potato tested.

DIRECTIONS FOR USE

GROUND APPLICATION

APPLICATION PROCEDURES
Use sufficient water (a minimum of 100 L/ha) to provide thorough uniform coverage.
Use sprayer nozzles that provide accurate, uniform application and medium-sized droplets.
Calibrate sprayer from manufacturer's instructions or provincial recommendations to ensure delivery of adequate spray volume per unit area.
Applications using sufficient water volume to provide thorough and uniform coverage generally provide the most effective aphid pest control. Use a minimum of 100 L/ha unless otherwise indicated in the Recommended Applications section of this label. In situations where a dense canopy exists and/or aphid infestations are high, use greater water volumes (i.e., at least 200 L/ha).

Mixing Procedures
Prepare no more spray mixture than is needed for the immediate application. Thoroughly clean spray equipment before using this product. Agitate the spray solution before and during application. Do not let the spray mixture stand overnight in the spray tank. Flush the spray equipment thoroughly following each use and apply the rinsate to a previously treated area. Keep product container tightly closed when not in use.

FULFILL 50WG Insecticide Alone
Add 1/2 of the required amount of water to the mix tank.
With the agitator running, add the FULFILL 50WG Insecticide to the tank.
Continue agitation while adding the remainder of the water.
Begin application of the solution after the FULFILL 50WG Insecticide has completely and uniformly dispersed into the mix water.
Maintain agitation until all of the mixture has been applied.
Note: Do not use liquid fertilizer as a carrier for FULFILL 50WG Insecticide.
Do not allow spray to drift onto adjacent land or crops.
Avoid application of this product when winds are gusty.
Avoid spraying when conditions are favorable for drift (high temperatures, low relative humidity, and drought). Do not apply during temperature inversions. If an inversion condition is suspected, consult with local weather services before making an application.
Use the largest droplet sizes consistent with good pest control. Small droplets are more prone to spray drift, and can be minimized by appropriate nozzle selection, by orienting nozzles away from the air stream as much as possible, and by avoiding excessive spray boom pressure.
Apply as close to target plants as practical to obtain a good spray pattern for adequate coverage. Applications more than 3 m above the crop canopy should be avoided.

DO NOT apply during periods of dead calm.
Do not apply FULFILL 50WG Insecticide through chemigation.
DO NOT apply with spray droplets smaller than the American Society of Agricultural Engineers (ASAE) medium classification.

AERIAL APPLICATION
Instruction for Aerial Application
Apply only by fixed-wing or rotary aircraft equipment which has been functionally and operationally calibrated for the atmospheric conditions of the area and the application rates and conditions of this label.
Label rates, conditions and precautions are product specific. Read and understand the entire label before opening this product. Apply only at the rate recommended for aerial application on this label. Where no rate for aerial application appears for the specific use, this product cannot be applied by any type of aerial equipment.
Ensure uniform application. To avoid streaked, uneven or overlapped application, use appropriate marking devices.

Use Precautions
Apply only when meteorological conditions at the treatment site allow for complete and even crop coverage. Apply only under conditions of good practice specific to aerial application as outlined in the National Aerial Application Manual, developed by the Federal/Provincial/Territorial Committee on Pest Management and Pesticides.
Do not apply to any body of water. Avoid drifting of spray onto any body of water or other non-target areas. Specified buffer zones should be observed.
Coarse sprays are less likely to drift, therefore, avoid combinations of pressure and nozzle type that will result in fine particles (mist). Do not apply during periods of dead calm or when wind velocity and direction pose a risk of spray drift. Do not spray when the wind is blowing towards a nearby sensitive crop, garden, terrestrial habitat (such as shelter-belt) or aquatic habitat.

Registered for culturesRatePreharvest Interval
Potatoes193 g14
Blueberries193 g85
Amaranth193 g14
Arugula193 g14
Cardoon193 g14
Celery193 g14
Celtuce193 g14
Chervil193 g14
Corn salad193 g14
Cress193 g14
Endive193 g14
Finocchio, florence fennel193 g14
Lettuce193 g14
Orach, atriplex193 g14
Parsley193 g14
Purslanes193 g14
Radicchio193 g14
Rhubarbs193 g14
Spinach193 g14
New zealand spinach193 g14
Chard193 g14