OnDeck
- Manufacturer
- CORTEVA
- Category
- Herbicides
- Registered until
- 2028-12-31
- Registration number
- 34709
GENERAL INFORMATION
OnDeck is a postemergence herbicide for the control of broadleaved weeds, green and yellow foxtail in spring wheat, durum wheat, winter wheat, and barley, not underseeded with legumes or forages. OnDeck Herbicide is mixed with water and applied as a uniform broadcast spray either by ground or aerial application.
OnDeck Herbicide contains tolpyralate a Group 27 (HPPD inhibitor) and bromoxynil a Group 6 (photosynthesis inhibitor) herbicides. OnDeck Herbicide most common symptoms include bleaching of new plant growth and yellowing of leaves (margins, tips or veins). Symptoms will appear soon after application (within 1-5 days), but full necrosis of target weeds may take longer depending upon growing conditions and weed susceptibility.
OnDeck Herbicide is absorbed by actively growing plant tissue and roots. Thorough coverage of the weeds is essential for consistent control.
OnDeck Herbicide must be applied early postemergence, to the main flush of actively growing weeds. Warm, moist growing conditions promote active weed growth and enhance the activity of OnDeck
Herbicide by allowing maximum foliar uptake and activity. Weeds hardened off by cold weather or drought stress may not be adequately controlled or suppressed and re-growth may occur. For best results, ensure thorough spray coverage of target weeds. Under certain environmental conditions slight delay on barley development can be present; the delay is transient and will not have an impact on yield. See DIRECTIONS FOR USE section of this label for complete use details.
GENERAL USE PRECAUTIONS
Sensitive Plants
Do not apply OnDeck Herbicide directly to, or otherwise permit it to come in direct contact with susceptible crops or desirable plants including tame oats, canola, alfalfa, edible beans, flax, flowers and ornamentals, lentils, lettuce, peas, potatoes, radishes, soybeans, sugar beets, sunflowers, tomatoes or tobacco.
Non-Target Sites
Do not apply where proximity of susceptible crops (e.g. canola and legumes) or other desirable plants is likely to result in exposure to spray or spray drift. See ENVIRONMENTAL PRECAUTIONS section of this label.
Tank Mixtures
This product may be tank mixed with a fertilizer, a supplement, or with registered pest control products, whose labels also allow tank mixing, provided the entirety of both labels, including Directions For Use,
Precautions, Restrictions, Environmental Precautions, and Spray Buffer Zones are followed for each product. In cases where these requirements differ between the tank mix partner labels, the most restrictive label must be followed. Do not tank mix products containing the same active ingredient unless specifically listed on this label.
In some cases, tank mixing pest control products can result in reduced pesticide efficacy or increased host crop injury. The user should contact Corteva Agriscience Canada Company at 1-800-667-3852 or www.corteva.ca for information before applying any tank mix that is not specifically recommended on this label.
Spray Equipment Precaution
Do not apply through any type of irrigation system.
To Reduce Spray Drift:
1. Use nozzles delivering higher volumes and coarser droplets.
2. Use low pressures (200 to 275 kPa).
3. Use a minimum of 100 L/ha of spray solution.
4. Spray when the wind velocity is 15 km/hr or less.
5. Spot treatments should only be applied with a calibrated boom to prevent over-application.
DIRECTIONS FOR USE
READ THE ENTIRE LABEL BEFORE USE. FAILURE TO FOLLOW LABEL INSTRUCTIONS MAY RESULT IN ERRATIC WEED CONTROL OR CROP DAMAGE. DO NOT APPLY TO CROPS UNDERSEEDED WITH LEGUMES.
As this product is not registered for the control of pests in aquatic systems, DO NOT use to control aquatic pests.
DO NOT contaminate irrigation or drinking water supplies or aquatic habitats by cleaning of equipment or disposal of wastes.
APPLICATION METHODS
Ground Application
Using ground equipment, apply OnDeck Herbicide as a broadcast treatment at the recommended rate as specifically listed in the DIRECTIONS FOR USE section of this label.
Field sprayer application
DO NOT apply during periods of dead calm. Avoid application of this product when winds are gusty.
DO NOT apply with spray droplets smaller than the American Society of Agricultural Engineers (ASAE S572.1) coarse classification. Boom height must be 60 cm or less above the crop or ground.
Aerial Application
DO NOT apply during periods of dead calm. Avoid application of this product when winds are gusty.
DO NOT apply when wind speed is greater than 16 km/h at flying height at the site of application.
DO NOT apply with spray droplets smaller than the American Society of Agricultural Engineers (ASAE S572.1) coarse classification. Reduce drift caused by turbulent wingtip vortices. Nozzle distribution along the spray boom length MUST NOT exceed 65% of the wing- or rotorspan.
Apply only by fixed-wing or rotary aircraft equipment which has been functionally and operationally calibrated for the atmospheric conditions of the area and the application rates and conditions of this label.
Label rates, conditions and precautions are product specific. Read and understand the entire label before opening this product. Apply only at the rate recommended for aerial application on this label. Where no rate for aerial application appears for the specific use, this product cannot be applied by any type of aerial equipment.
Ensure uniform application. To avoid streaked, uneven or overlapped application, use appropriate marking devices or a GPS system.
Registered for cultures |
---|
Spring wheat |
Winter wheat |
Durum Wheat |