Rustler Liquid

Registered until: December 31, 2024
Monsanto - herbicide


Store product in original container only, away from other pesticides, fertilizer, food or feed. Not for use or storage in or around the home. Store above 5 C to keep product in solution. If crystals form, place in a warm room (20 C), allow the product to reach room temperature and roll or shake periodically until crystals have redissolved. Keep container closed to prevent spills and contamination.

Do not reuse container for any other purpose.
For disposal, this empty container may be returned to the point of purchase (distributor/dealer).
For disposal, this container may be returned to the point of purchase (distributor/dealer). It must be refilled by the distributor/dealer with the same product. Do not reuse this container for any other purpose.
Do not reuse this container for any purpose. This is a recyclable container and is to be disposed of at a container collection site. Contact your local distributor/dealer or municipality for the location of the nearest collection site. Before taking the container to the collection site:
1. Triple- or pressure-rinse the empty container. Add the rinsing to the spray mixture in the tank.
2. Make the empty, rinsed container unsuitable for furtheruse.
If there are no container collection sites in your area, dispose of the container in accordance with provincial requirements.
For information on the disposal of unused, unwanted product, contact the Provincial Regulatory Agency or the manufacturer. Contact the manufacturer and the provincial regulatory agency in case of a spill, and for clean-up of spills.

Rustler Liquid Herbicide is a postemergent herbicide for control or suppression of emerged weeds prior to seeding cereals in reduced tillage operations and in fallow land.
This product enters the plant through the foliage and moves throughout the plant. Visual effects of control are gradual wilting or yellowing of the plant, which advances to complete browning of above-ground growth and deterioration of affected underground plant parts. Visible symptoms will usually develop on labeled weeds within 5 to 7 days after applications, but may not occur for more than 7 days. Extremely cool or cloudy weather following treatment or prolonged drought conditions may slow activity of this product and delay the visual effects of control. Always use the higher rate of this product per hectare when weeds are under poor growing conditions, such as drought.
Reduced control may result if treatments are made during poor growing conditions such as drought stress, disease or insect damage, or if weeds have been mowed, grazed or cut. Heavy dust on foliage or an overstory canopy covering targeted weeds may also reduce control.
This product does not provide residual weed control. For subsequent residual weed control, follow a label-approved herbicide program. Read and carefully observe the precautionary statements and all other information appearing on the labels of all herbicides used.
Rainfall occurring with 6 hours after application, particularly on weeds growing under stress conditions, may reduce the effectiveness of this product. Heavy rainfall within 2 hours after application may wash the chemical off the foliage and a repeat treatment may be required.  For best results spray coverage should be uniform and complete.

Fill the spray tank to about 3/4 of the desired volume with clean water. Add the recommended amount of Rustler Liquid Herbicide, then complete the filling process while maintaining agitation. Remove the hose from the mix tank immediately after filling to avoid siphoning back into the carrier source. During mixing and application, foaming of the spray solution may occur. To prevent or minimize foam, terminate by- pass and return lines at the tank bottom during mixing.
NOTE: Reduced results may occur if water containing soil is used, such as water from ponds and unlined ditches.

Recommended applications of this product can be made as required prior to seeding in cereal crops and to fallow land.
This product or labeled tank mixtures should be applied to emerged, actively growing weeds.  Application at earlier growth stages generally will provide best results.
Reduced results may occur if application of this product or labeled tank mixtures are made to weeds which are not actively growing or weeds that are drought stressed.
For additional information and precautions refer to the “GENERAL INFORMATION”, “MIXING INSTRUCTIONS” and “APPLICATION PRECAUTIONS” sections of this
Apply this product at 2.5 to 3.125 L/ha in 50 to 100 litres of clean water per hectare. The higher rate of this product should be applied when weeds are under poor growing conditions such as drought or for those weeds specified in the table below.
When applied as recommended, this product will control weeds as outlined in the following “WEEDS CONTROLLED” table.
DO NOT apply this product directly to freshwater habitats (such as lakes, rivers, sloughs, ponds, prairie potholes, creeks, marshes, streams, reservoirs and wetlands), estuarine or marine habitats.
DO NOT contaminate irrigation or drinking water supplies or aquatic habitats by cleaning of equipment or disposal of wastes.
Field sprayer application: DO NOT apply during periods of dead calm. Avoid application of this product when winds are gusty. DO NOT apply with spray droplets smaller than the American Society of Agricultural Engineers (ASAE) medium/coarse classification (according to the appropriate buffer zonetable).
Boom height must be 60 cm or less above the crop or ground.

0 - 0
Registred norm
2.5 - 3.125
Preharvest Interval