ZingPlant Protection Product ComparisonPlant Protection Product ComparisonReport inaccuraciesReport inaccuracies

GENERAL INFORMATION

Zing! is a broad-spectrum protectant fungicide. Optimum disease control is achieved when the fungicide is used according to label directions and applied in a regularly scheduled preventative spray program.
The use of Zing! is compatible with the principles of Integrated Pest Management (IPM) and programs that attempt to minimize disease resistance to fungicides. Unlike single-site mode of action fungicides which are at risk from disease resistance, Zing!, with a multi-site mode of action, may be used to delay or prevent the development of resistance to single site fungicides.

DIRECTION FOR USE

GENERAL USE PRECAUTIONS
As this product is not registered for the control of pests in aquatic systems, DO NOT use to control aquatic pests.
DO NOT contaminate irrigation or drinking water supplies or aquatic habitats by cleaning of equipment or disposal of wastes.
READ ALL DIRECTIONS CAREFULLY BEFORE APPLYING. FAILURE TO FOLLOW LABEL
INSTRUCTIONS MAY RESULT IN ERRATIC FUNGICIDE CONTROL OR CROP DAMAGE.

Use Rate Determination
Carefully read, understand, and follow label use rates and restrictions. Under low disease conditions, minimum label rates per application can be used while maximum label rates and the minimum interval may be used for severe or threatening disease conditions. For proper application, determine the number of hectares to be treated, the recommended label use rate and the water to be applied per hectare.
Prepare only the amount of spray solution required to treat the measured area. Careful calibration of spray equipment is recommended prior to use.
Do not re-enter treated areas within 48 hours of application.

MIXING INSTRUCTIONS
Slowly place into spray tank as it is being filled or thoroughly premix in a nurse tank for concentrate or aircraft sprayers. Add other co-applied fungicides after ZING! Fungicide has been placed into suspension.
Dosage rates on this label indicate litres per hectare of Zing!, unless otherwise stated. Under conditions favoring disease development the highest rate specified and shortest application interval should be used.
Tank Mixtures: Do not apply this product with any other additive, pesticide or fertilizer except as specifically recommended on this label.

APPLICATION DIRECTIONS

GROUND Application Directions for Use
Thorough coverage foliar sprays generally result in optimum disease control. To achieve good coverage use proper spray pressure, water volume per hectare, nozzles (generally hollowcone), disc (generally D5 to D7), nozzle spacing, and tractor speed. Consult spray nozzle accessory catalogues for specific information on proper equipment calibration.

AERIAL Application Directions for Use
Apply only by fixed-wing or rotary aircraft equipment which has been functionally and operationally calibrated for the atmospheric conditions of the area and the application rates and conditions of this label. 
Label rates, conditions and precautions are product specific. Read and understand the entire label before opening this product. Apply only at the rate recommended for aerial application on this label. Where no rate for aerial application appears for the specific use, this product cannot be applied by any type of aerial equipment.
Ensure uniform application. To avoid streaked, uneven or overlapped application, use appropriate marking devices

Aerial Use Precautions
Apply only when meteorological conditions at the treatment site allow for complete and even crop coverage. Apply only under conditions of good practice specific to aerial application as outlined in the
National Aerial Pesticide Application Manual, developed by the Federal/Provincial/Territorial Committee on Pest Management and Pesticides.

Aerial Operator Precautions
Do not allow the pilot to mix chemicals to be loaded onto the aircraft. Loading of premixed chemicals with a closed system is permitted.
It is desirable that the pilot have communication capabilities at each treatment site at the time of application.
The field crew and the mixer/loaders must wear chemical resistant gloves, coveralls and goggles or face shield during mixing/loading, cleanup and repair. Follow the more stringent label precautions in cases where the operator precautions exceed the generic label recommendations on the existing ground boom label.
All personnel on the job site must wash hands and face thoroughly before eating and drinking. Protective clothing, aircraft cockpit and vehicle cabs must be decontaminated regularly.