EvolyaPlant Protection Product ComparisonPlant Protection Product ComparisonReport inaccuraciesReport inaccuracies

DIRECTIONS FOR USE
IMPORTANT: This information is approved as part of the Product Label. All instructions within this section must be carefully read in order to obtain safe and successful use of this product.

GENERAL INFORMATION
EVOLYA contains mesotrione a foliar applied herbicide for selective control of annual broad-leaved weeds. The activity of EVOLYA is mostly by foliar uptake and to some extent by soil uptake. EVOLYA is rapidly absorbed through the leaves and moves to the growing point.

Crops
For use only as a herbicide for the control of weeds in forage maize and grain maize . DO NOT USE on forage maize and grain maize seed crops or on sweet corn varieties.

Spray timing
Always inspect crop and weed growth stage immediately before spraying. For the best results treat young weed seedlings. See weed control table for application details.

CONDITIONS FOR USE
Crops

Forage maize and grain maize may be sprayed any time from the two to nine leaf stage (BBCH 12-19).

Weather
For the best results EVOLYA should be applied when the weeds are actively growing i.e. in warm humid weather with adequate soil moisture. Treatment in poor growing conditions or in dry soil may give less reliable control. Do not spray when weed or crop foliage is wet.

MIXING AND SPRAYING
Preparation of the spray solution
Shake thoroughly the EVOLYA container. Half fill the spray tank with clean water and begin agitation. Add the required quantity of EVOLYA to the tank and complete filling. Continue agitation until spraying is completed.

Application
Application of EVOLYA will be achieved by using conventional ground spraying equipment at water volumes of 200-400 L/ha. Do not spray EVOLYA post emergence of the crop if any rainfall is expected in the next 6 hours.

After Use
It is important to wash equipment thoroughly after use to remove all traces of EVOLYA as even small amounts may cause damage to crops. Rinse inside of tank with clean water using at least one tenth of the spray tank volume. After flushing through pump and spray lines, drain and repeat procedure.
Disposal of spray tank washings should be in accordance with local, state or national legislation.