Acephate 90 WSP

Manufacturer
Loveland Products
Category
Insecticides
Registered until
N/A
Registration number
34704-862
Active materials
Links

PRODUCT INFORMATION
Acephate 90 WSP is an insecticide which controls a wide range of important pests in selected crops and in non-crop areas. The active ingredient is acephate, a water-soluble insecticide readily absorbed by plant roots and foliage to give systemic control of feeding insects. Insect pests are generally controlled more effectively by Acephate 90 WSP through ingestion than by contact. Repeat application of Acephate 90 WSP to maintain control only as directed. FAILURE TO FOLLOW THE DIRECTION FOR USE AND PRECAUTIONS ON THIS LABEL MAY RESULT IN POOR INSECT CONTROL, CROP INJURY, AND/OR ILLEGAL RESIDUES.

TANK MIXES
NOTICE: Tank mixing of this product with any other product which is not specifically and expressly authorized by the label shall be at the exclusive risk of the user, applicator, and/or application advisor. Read and follow the entire label of each product to be used in the tank mix with this product.

CHEMIGATION
Apply only to cranberries with sprinkler irrigation systems and do not use any other type of irrigation systems. Do not apply this product through chemigation to any other crop.

SPRAY DRIFT
A variety of factors including weather conditions, (e.g., wind direction, wind speed, temperature, relative humidity) and method of application (e.g., ground aerial, airblast, chemigation) can influence pesticide drift. The applicator and grower must evaluate all factors and make appropriate adjustments when applying this product. Do not allow this product to drift. Observe the following precautions to minimize drift:
•All aerial, ground and air-assisted/airblast application equipment must be properly maintained and calibrated using water as carrier.
Do not apply this product as an ultralow volume (ULV) spray except as specified in the instructions for use on non-crop wasteland.
Do not apply in any carrier other than water.
«Use the largest droplet size consistent with good pest control. Small droplets are more prone to spray drift and can be minimized by appropriate nozzle selection, by orienting nozzles away from the air stream as much as possible, and by avoiding excessive spray boom pressure.
• Do not apply at wind speeds greater than 10 mph at the application site.
o Make applications when wind velocity favors on-target product deposition (approximately 3 to 10 mph).
° Apply as close to target plants as practical to obtain a good spray pattern for adequate coverage.

For Aerial Applications:
• Do not apply at heights greater than 10 feet (consistent with flight safety).
• The spray boom should be mounted on the aircraft so as to minimize drift caused by wing tip vortices.
• The minimum practical boom length should be used and must not exceed 75% of wing span or rotor diameter.

For Ground Applications:
° Do not apply at heights greater than 4 feet.

For Airblast Applications:
« Direct spray above foliage and turn off outward pointing nozzles at row ends and outer rows.

Registered for cultures
Cotton