Agrisel Acephate Pro 75 InsecticidePlant Protection Product ComparisonPlant Protection Product ComparisonReport inaccuraciesReport inaccuracies

DIRECTIONS FOR USE
It is a violation of Federal law to use this product in a manner inconsistent with its labeling. READ ENTIRE LABEL. USE STRICTLY IN ACCORDANCE WITH PRECAUTIONARY STATEMENTS AND DIRECTIONS FOR USE AND WITH APPLICABLE STATE AND FEDERAL REGULATIONS.
Do not apply using low pressure handwand equipment.
Not for indoor residential use. For greenhouse use, use is limited to commercial greenhouses for use on ornamental, floral and foliage plants, and tobacco (float bed application).
For use on turf, use limited to sod farms and golf courses, except when applying to mound or spot treatment for fire ant control.
Do not apply this product in a way that will contact workers or other persons, either directly or through drift. Only protected handlers may be in the area during application. For any requirements specific to your State or Tribe, consult the agency responsible for pesticide regulation.

DRIFT MANAGEMENT
A variety of factors including weather conditions, (e.g. wind direction, wind speed, temperature, relative humidity) and method of application (e.g. ground, aerial, Airblast, chemigation) can influence pesticide drift. The applicator and grower must evaluate all factors and make appropriate adjustments when applying this product.
Observe the following precautions to minimize drift:
• All aerial, ground and air-assisted/airblast application equipment must be properly maintained and calibrated using water as carrier. Do not apply this product as an ultralow (ULV) spray or in any carrier other than water except when specified by the Use Instructions.
• Use the largest droplet size consistent with good pest control. Small droplets are more prone to spray drift and can be minimized by appropriate nozzle selection, by orienting nozzles away from the air stream as much as possible, and by avoiding excessive spray boom pressure.
• Do not apply at wind speeds greater than 10 mph at the application site.
• Make applications when wind velocity favors on-target product deposition (approximately 3 to 10 mph).
• Apply as close to target plants as practical to obtain a good spray pattern for adequate coverage.
• For aerial applications, do not apply at heights greater than 10 feet (consistent with flight safety).
• For airblast applications, direct spray above foliage and turn off outward pointing nozzles at row ends and outer rows.
• For aerial applications, the spray boom should be mounted on the aircraft so as to minimize drift caused by wing tip vortices. The minimum practical boom length should be used and must not exceed 75% of wing span or rotor diameter.
• For ground applications, do not apply at heights greater than 4 feet.
Do not apply this product in a way that will contact workers or other persons, either directly or through drift. Only protected handlers may be in the area during application. Do not allow this product to drift.