Azure Xtra FungicidePlant Protection Product ComparisonPlant Protection Product ComparisonReport inaccuraciesReport inaccuracies

FIGHT FOLIAR DISEASES

• Combats disease through curative and residual preventive control
• Two modes of action deliver built-in resistance management
• Formulated for easy aerial application methods

USE SUMMARY

CEREALS
Application may be made as foliar sprays in alternating spray programs or in tank mixes with
other crop protection products. Apply Azure™ Xtra with the following times and rates:

For early-season suppression of glume blotch, leaf blight, powdery mildew and tan spot: Use 3.5 fl oz per acre. Apply this product in the spring approximately Feekes Stage 5. The minimum retreatment interval is 14 days. Apply by ground, air, or chemigation. If applied by chemigation, the maximum amount of water should be 0.25 inches.

For control of leaf diseases: Use 5.0-6.8 fl oz per acre. Apply this product between Feekes Stage 8 and 10.5.1. Protecting the flag leaf is important for maximizing the potential yield. The minimum retreatment interval is 14 days. Treat up to 30 days prior to harvest. Apply by ground, air, or chemigation.

SOYBEAN
Application may be made as foliar spray in alternating spray program or in tank mix with
other crop protection products. Apply Azure Xtra with the following times and rates:

Coverage and penetration are important for best results. Use sufficient water volume to provide thorough and uniform plant coverage. Apply by ground, air, or chemigation. Addition of an additive with spreading and penetrating qualities will enhance coverage and efficacy.

For soybean rust: Apply 4.0-6.8 fl oz/A. Repeat at 14-28 day interval if conditions persist for rust development. Lower use rates may require a shorter spray interval. Depending on the conditions, application timing should be R1 (beginning flowering, approximately 50 days after planting) up to R6 stage (seed development), but could be earlier.

For diseases other than soybean rust: For best results, apply 5.0-6.8 fl oz/A and begin application prior to disease development. Use the higher rates under conditions favorable for severe disease pressure, dense plant canopies, or when disease is present. Contact extension personnel for local economic thresholds and timings for specific diseases in your area. An adjuvant may be added at recommended rates to improve coverage.