Delaro CompletePlant Protection Product ComparisonPlant Protection Product ComparisonReport inaccuraciesReport inaccuracies

DIRECTIONS FOR USE

It is a violation of Federal law to use this product in a manner inconsistent with its labeling. Read the entire label before using this product. Do not apply this product in a way that will contact workers or other persons, either directly or through drift Only protected handlers may be in the area during application For any requirements specific to your State or Tribe, consult the agency responsible for pesticide regulation

PRODUCT INFORMATION

Delaro Complete:

• is a broad spectrum fungicide for the control of certain diseases of Corn, Soybean, Sweet corn and Wheat;

• works by interfering with both energy and cell membrane production by plant pathogenic fungi Equipment must be properly calibrated before use

USE RESTRICTIONS

• Under certain conditions conducive to extended infection periods, additional fungicide applications beyond the number allowed by this label may be needed Under these conditions, use another fungicide registered for the crop/disease

• Do not apply more than 2 sequential applications of DELARO Complete or any other QoI Group 11 or Group 7 containing fungicide without alternation with a fungicide from another group

• Not registered for aerial application in New York State Refer to the specific use directions and restrictions in each Crop table

APPLICATION INSTRUCTIONS

• DELARO Complete may be applied by ground, air (except in New York), or chemigation • Use of an adjuvant may enhance the performance of DELARO Complete

Aerial Application

Avoid application under conditions when uniform coverage cannot be obtained or when excessive spray drift may occur Do not apply directly to humans or animals Not registered for aerial application in New York State Refer to specific crop sections for water carrier volume restrictions

Ground Application

(Broadcast) Equip sprayers with nozzles that provide accurate and uniform application Nozzle selection, spraying pressures, carrier volume and application speeds are critical for maximum efficacy Select nozzles that deliver Fine to Medium droplets and operate them within the pressures specified by the manufacturer Adjust application speeds to allow for canopy penetration and coverage of the leaf surface Be certain that nozzles are the same size and uniformly spaced across the boom Calibrate the sprayer before use and replace worn or damaged nozzles Use a pump with sufficient agitation capacity in the tank to keep the mixture in suspension This requires recirculation of 10% of the tank volume per minute Use jet agitators or a liquid spurge tube for vigorous agitation Use screens to protect the pump and to prevent nozzles from clogging Check nozzle manufacturer’s recommendations For information on spray equipment and calibration, consult sprayer manufacturer’s and/or state recommendations For specific local directions and spray schedules, consult the current state agricultural experiment station recommendations.