DelightPlant Protection Product ComparisonPlant Protection Product ComparisonReport inaccuraciesReport inaccuracies

PRODUCT INFORMATION

Delight is a broad-spectrum fungicide for the control of certain diseases of barley, corn, cotton, dried shelled pea and bean - except soybean (Subgroup 6C), flax, peanut, soybean, sugar beets, sweet corn, and wheat This product works by interfering with both energy and cell membrane production by plant pathogenic fungi Equipment must be properly calibrated before use Use Restrictions:

• DO NOT apply more than 2 sequential applications of Delight or any other QoI Group 11 fungicide without alternation with a fungicide from another group

• Under certain conditions conducive to extended infection periods, additional fungicide applications beyond the number allowed by this label may be needed Under these conditions, use another fungicide registered for the crop/disease

• Not registered for aerial application in New York State

• DO NOT use with handheld application equipment, including mechanically pressurized spray gun, backpack or tank pressurized spray gun or handheld boom applicators Refer to the SPECIFIC CROP DIRECTIONS and Restrictions in each Crop table

APPLICATION INSTRUCTIONS

• Delight may be applied by ground, air (except in New York), or chemigation

• Use of an adjuvant may enhance the performance of Delight

• Under certain conditions conducive to extended infection periods, additional fungicide applications beyond the number allowed by this label may be needed Under these conditions, use another fungicide registered for the crop/disease.

Aerial Application

Avoid application under conditions when uniform coverage cannot be obtained or when excessive spray drift may occur DO NOT apply directly to humans or animals Not registered for aerial application in New York State Refer to specific crop sections for water carrier volume recommendations

Ground Application

Applications using sufficient water volume to provide thorough and uniform coverage generally provide the most effective disease control Refer to specific crop sections for water carrier volume recommendations

Ground Application (Broadcast)

Equip sprayers with nozzles that provide accurate and uniform application Nozzle selection, spraying pressures, carrier volume and application speeds are critical for maximum efficacy Select nozzles that deliver Fine to Medium droplets and operate them within the pressures specified by the manufacturer Adjust application speeds to allow for canopy penetration and coverage of the leaf surface Be certain that nozzles are the same size and uniformly spaced across the boom Calibrate the sprayer before use and replace worn or damaged nozzles Use a pump with sufficient agitation capacity in the tank to keep the mixture in suspension This requires recirculation of 10% of the tank volume per minute Use jet agitators or a liquid spurge tube for vigorous agitation Use screens to protect the pump and to prevent nozzles from clogging Check nozzle manufacturer’s recommendations For information on spray equipment and calibration, consult sprayer manufacturer’s and/or State recommendations