Dicamba 4 LBPlant Protection Product ComparisonPlant Protection Product ComparisonReport inaccuraciesReport inaccuracies

For weed control in corn, sorghum, small grains, pasture, hay, rangeland, general farmstead (noncropland), rights-of-way, public utility and industrial areas, fallow, sugarcane, asparagus, turf, and grass seed crops.

PRODUCT INFORMATION
The following directions apply to all uses of DICAMBA 4LB Herbicide. Additional precautions and restrictions will be found in each specific use section.
x DO NOT treat irrigation ditches or water used for crop irrigation or domestic uses.
x DO NOT apply this product through any type of irrigation system.
x DO NOT apply more than 1 lb of dicamba/A per application and no more than 2 applications per year.

RESISTANCE MANAGEMENT
For resistance management, DICAMBA 4LB Herbicide is a Weed Science Society of America Group 4 Herbicide listed under the Herbicide Resistant Action Committee (HRAC). Any weed population may contain or develop plants naturally resistant to DICAMBA 4LB Herbicide and other Group 4 Herbicides.
The resistant biotypes may dominate the weed population if these herbicides are used repeatedly in the same field. Where possible, rotate the use of DICAMBA 4LB Herbicide with herbicides that have a different mode of action.
Other resistance mechanisms that are not linked to site of action, but specific for individual chemicals, such as enhanced metabolism, may also exist. If poor performance occurs and cannot be attributed to adverse weather or application conditions, a resistant biotype may be present.
The use of DICAMBA 4LB Herbicide should conform to resistance management strategies established for the use area. Consult your agricultural advisor for resistance management strategies and recommended pest management practices for your area. Appropriate resistance management strategies should be
followed.

MIXING AND APPLICATION
UNLESS OTHERWISE SPECIFIED UNDER THE INDIVIDUAL USE HEADINGS OF THIS BOOKLET, THE FOLLOWING DIRECTIONS APPLY TO ALL CROP AND NON-CROP USES OF DICAMBA 4LB Herbicide. REFER TO INDIVIDUAL USE SECTIONS FOR ADDITIONAL PRECAUTIONS, RESTRICTIONS, APPLICATION RATES, AND TIMINGS.
DICAMBA 4LB Herbicide is a water-soluble formulation that can be applied using water or sprayable fluid fertilizer as the carrier. If a fluid fertilizer is to be used, a compatibility test (see COMPATIBILITY TEST) should be made prior to tank mixing.
Use ground or aerial application equipment that will give good spray coverage of weed foliage. HOWEVER, DO NOT USE AERIAL APPLICATION EQUIPMENT IF SPRAY PARTICLES CAN BE CARRIED BY WIND INTO AREAS WHERE SENSITIVE CROPS OR PLANTS ARE GROWING OR WHEN TEMPERATURE INVERSIONS EXIST.
Apply 3–50 gallons of diluted spray per treated acre when using ground application equipment or 1–10 gal of diluted spray per treated acre (2–20 gal of diluted spray per treated acre for preharvest uses) in a waterbased carrier when using aerial application equipment. Use the higher level of the listed spray volumes
when treating dense or tall vegetation. Use coarse sprays. Select nozzles designed to produce minimal amounts of fine spray particles. Spray with nozzles as close to the weeds as is practical for good weed coverage. To prevent uneven spray coverage and drift, DICAMBA 4LB Herbicide should not be applied during
periods of gusty wind or when wind is in excess of 15 mph. Avoid disturbing (e.g., cultivating or mowing) treated areas for at least 7 days following application