Dicamba DMA 4 AG
The following directions apply to all uses of DICAMBA DMA 4# AG herbicide. Additional precautions and restrictions will be found in each specific use section.
DO NOT treat irrigation ditches or water used for crop irrigation or domestic uses.
DO NOT apply this product through any type of irrigation system.
MIXING AND APPLICATION
UNLESS OTHERWISE SPECIFIED UNDER THE INDIVIDUAL USE HEADINGS OF THIS BOOKLET, THE FOLLOWING DIRECTIONS APPLY TO ALL CROP AND NON-CROP USES OF DICAMBA DMA 4# AG. REFER TO INDIVIDUAL USE SECTIONS FOR ADDITIONAL PRECAUTIONS, RESTRICTIONS APPLICATION RATES, AND TIMINGS.
DICAMBA DMA 4# AG is a water soluble formulation that can be applied using water or sprayable fluid fertilizer as the carrier. If a fluid fertilizer is to be used, a compatibility test (see COMPATIBILITY TEST) should be made prior to tank mixing.
DO NOT apply more than 2 pts of DICAMBA DMA 4# AG (1 Ib dicamba) per acre for any single application.
DO NOT exceed more than 4 pts of DICAMBA DMA 4# AG (2 Ibs dicamba) per acre per year. Ground or aerial application equipment which will give good spray coverage of weed foliage should be used. HOWEVER, DO NOT USE AERIAL APPLICATION EQUIPMENT IF SPRAY PARTICLES CAN BE CARRIED BY WIND INTO AREAS WHERE SENSITIVE CROPS OR PLANTS ARE GROWING OR WHEN TEMPERATURE INVERSIONS EXIST.
Apply 3 to 50 gallons of diluted spray per treated acre when using ground application equipment or 1 to 10 gallons of diluted spray per treated acre (2 to 20 gallons of diluted spray per treated acre for preharvest uses) in a water-based carrier when using aerial application equipment. Use the higher level of the listed
spray volumes when treating dense or tall vegetation. Use coarse sprays. Select nozzles designed to produce minimal amounts of fine spray particles. Spray with nozzles are close to the weeds as is practical for good weed coverage.
To avoid uneven spray coverage, DICAMBA DMA 4# AG should not be applied during periods of gusty wind or when wind is in excess of 15 mph.
Avoid disturbing (e.g., cultivating or mowing) treated areas for at least 7 days following application.
|Registered for cultures|