Dimate 4EPlant Protection Product ComparisonPlant Protection Product ComparisonReport inaccuraciesReport inaccuracies

DIRECTIONS FOR USE
It is a violation of Federal law to use this product in a manner inconsistent with its labeling. Do not apply this product in a way that will contact workers or other persons, either directly or through drift. Only protected handlers may be in the area during application. For any requirements specific to your State or Tribe, consult the agency responsible for pesticide regulation. This product is for use in commercial settings only. Use in residential settings is prohibited. DO NOT use this product on crops grown in greenhouses. This product may be used to control the types of insects listed in the tables in this section of the label on the fruit crops, nut crops, vegetable crops, field crops, and other crops listed in those tables. This product may be applied using ground sprayers, aircraft, or the types of irrigation systems indicated under "Application through Irrigation Systems."

Resistance Management
Dimate 4E contains a Group 1B insecticide or acaricide. Insect/mite biotypes with acquired resistance to Group 1B may eventually dominate the insect/mite population if Group 1Binsecticides or acaricides are used repeatedly in the same field or in successive years as the primary method of control for targeted species. This may result in partial or total loss of control ofthose species by this product or other Group 1B insecticides or acaricides.
To delay insecticide or acaricide resistance consider:
• Avoiding the consecutive use of this product or other Group 1B insecticides/acaricides that have similar target site of action on the same insect/mite species.
• Using tank mixtures or premixes with insecticides/acaricides from a different target s'iteaction Group as long as the involved products are all registered for the same use and have different sites of action.
• Basing insecticide/acaricide use on a comprehensive IPM program.
• Monitoring treated insect/mite populations for loss of field efficacy.
• Contacting your local extension specialist, certified crop advisors,. and/or Winfield Solutions, LLC representative for insecticide/acaricide resistance management and/or IPM recommendations for specific site arid resistant pest populations.

Mixing Directions
Mix this product in water to form an emulsion spray mixture. To make the emulsion, fill the spray tank half way with water. Agitate and add the proper amount of this product (see "Crops and Sites" table and "Ornamentals" for crop to be treated). Then fill the spray tank with water while still agitating. Continue to agitate mixture during use. The hazards and precautions associated with handling this product apply to it equally before and after it is diluted with water for spray application.