Metribuzin 4 LPlant Protection Product ComparisonPlant Protection Product ComparisonReport inaccuraciesReport inaccuracies

DIRECTIONS FOR USE
It is a violation of Federal law to use this product in a manner inconsistent with its labeling.
Do not apply this product in a way that will contact workers or other persons, either directly or through drift. Only protected handlers may be in the area during application. For any requirements specific to your State or Tribe, consult the agency responsible for pesticide regulation.

GENERAL INFORMATION
Metribuzin 4L cannot be applied with low pressure or high volume hand wand equipment.

MIXING
When using Metribuzin 4L, make sure the sprayer is completely clean, free of rust or corrosion which occurs from Winter storage. Examine strainers and screens to be sure the sprayer is clean from previously used pesticides. Any tank mix containing Metribuzin 4L should be kept agitated and sprayed out immediately. Do not allow tank mixes to stand for prolonged periods of time.
The proper mixing procedure for Metribuzin 4L alone or in tank mix combinations with other herbicides is:
1. Fill the spray tank 1/4 to 1/3 full with clean water.
2. Add specified rate of Metribuzin 4L while recirculating and with agitator running.
3. Follow the triple rinse procedure described under STORAGE AND DISPOSAL
to insure that all product is removed from the container.
4. Mix thoroughly and add clean water to fill spray tank to desired level.
5. Add the other herbicide to tank last and agitate thoroughly.
6. Continue agitation during application and until sprayer tank is empty.
SOIL TEXTURE: As used on this label, "Coarse soils" are loamy sand or sandy loam soils. "Medium soils" are loam, silt loam, silt, sandy clay, or sandy clay loam.
"Fine soils" are silty clay, silty clay loam, clay, or clay loam. Silty clay loam soils are transitional soils and may be classified as medium textured soils in some regions of the U.S.

GENERAL PRECAUTIONS AND RESTRICTIONS
• Do not use on other crops grown for food or forage. Apply this product only as specified on this label. Do not rotate any crop not listed on this label for 18 months following application of Metribuzin 4L.
• Do not allow sprays to drift on to adjacent desirable plants.
• Observe all cautions and limitations on labeling of all products used in mixtures.
• For all uses: Low pressure and high volume hand wand equipment is prohibited.

CHEMIGATION
Metribuzin 4L is recommended for application through sprinkler irrigation equipment to potatoes, soybeans, tomatoes, and asparagus as directed on this label.
Refer to the crop sections of this label for rates, weeds controlled or suppressed, restrictions, and special precautions.
Apply this product only through sprinkler (including center pivot, lateral move, or solid set) irrigation systems. Do not apply this product through any other type of
irrigation system. Crop injury, lack of effectiveness, or illegal pesticide residues in the crop can result from nonuniform distribution of treated water.