Nufarm Propiconazole 41.8 EC FungicidePlant Protection Product ComparisonPlant Protection Product ComparisonReport inaccuraciesReport inaccuracies

DIRECTIONS FOR USE
It is a violation of Federal law to use this product in a manner inconsistent with its labeling. Do not apply this product in a way that will contact workers or other persons, either directly or through drift. Only protected handlers may be in the area during application. For any requirements specific to your State or Tribe, consult the agency responsible for pesticide regulation.

RESISTANCE MANAGEMENT
This product is effective in controlling pests and minimizing the development of resistance when used in rotation with other fungicides in an IPM program. To reduce selection pressure for resistant pests:
• Use this product in rotation with classes of fungicides with different modes of action.
• Use this product as part of a pest management program that includes cultural and biological control where possible.
• This product is in the Group 3 class of fungicides. The mode of action for propiconazole, the active ingredient in this product, is as a demethylation inhibitor of sterol biosynthesis (OMI) which disrupts membrane synthesis by blocking demethylation. Resistance can develop when products with the same mode of action are used repeatedly.
• Consult your State or local agricultural pest control advisor(s) for pest control strategies established for your area.

Aerial Application: For those crops other than tree crops where aerial applications are indicated, apply in a minimum of 2 gals. of water per acre, unless specified otherwise in the CROP APPLICATION INSTRUCTIONS section of this label. For tree 'crops, a minimum of 5 to 10 gals. of water per acre is specified using the higher volume on large trees unless specified otherwise in the CROP APPLICATION INSTRUCTIONS section of this label. 

Ground Application: For tree crops, a minimum of 50 gals. of water per acre is specified unless specified otherwise in the CROP APPLICATION INSTRUCTIONS section of this label. For all other crops, I apply this product by ground equipment in a minimum of 10 gals. of water per acre unless specified otherwise in the CROP APPLICATION INSTRUCTIONS section of this label.
Chemigation: Apply this product through irrigation equipment only to crops for which chemigation is specified on this label or on approved supplemental labeling provided by Nufarm. Apply in 0.1 to 0.25 inches of water. Chemigation with excessive water negatively impacts efficacy of the product.
Precaution(s): Do not inject this product at full strength or deterioration of valves and seals will occur. Use a dilution ratio of at least 10 parts water to 1 part product. This product is corrosive to many seal materials. Leather seals are best. EPDM or silicone rubber seals can be used but should be replaced once a year, Do not use Viton, Buna-N, Neoprene, or PVC seals.
Apply this product alone or in combination with other pesticides which are registered for application through irrigation systems through irrigation systems . Apply this product only through center pivot, solid set, hand move, or moving wheel irrigation systems. Do not apply this product through any other type of irrigation system. Crop injury, lack of effectiveness, or illegal pesticide residues in the crop can result from non-uniform distribution of treated water. If you have questions about calibration, you should contact State Extension Service specialists, equipment manufacturers, or other experts.
Do not connect an irrigation system (including greenhouse systems) used for pesticide application to a public water system unless the pesticide label-prescribed safety devices for public water systems are in place.
A person knowledgeable of the chemigation system and responsible for its operation, or under the supervision of the responsible person, shall shut the system down and make necessary adjustments should the need arise.