RevylokPlant Protection Product ComparisonPlant Protection Product ComparisonReport inaccuraciesReport inaccuracies

Directions For Use

It is a violation of federal law to use this product in a manner inconsistent with its labeling This labeling must be in the user’s possession during application Read the entire Directions For Use and Conditions of Sale and Warranty before using this product

Use Restrictions

• DO NOT use in greenhouse production or transplant production systems

• DO NOT apply this product in a way that will contact workers or other persons, either directly or through drift Only protected handlers may be in the area during application For any requirements specific to your state or tribe, consult the agency responsible for pesticide regulation

• Revylok fungicide is not for sale, distribution, or use in Nassau and Suffolk counties in New York State

Product Information

Revylok fungicide is a broad spectrum fungicide containing the active ingredients mefentrifluconazole and fluxapyroxad For optimum disease control, apply Revylok in a regularly scheduled protective spray program and use in a rotation program with other non-Group 3 and non-Group 7 fungicides

Mode of Action

Each of the components in Revylok provides a different mode of action against plant pathogenic fungi Mefentrifluconazole inhibits demethylation of sterol biosynthesis (DMI) which disrupts cell membrane synthesis and is classified by FRAC as a Group 3 fungicide Fluxapyroxad belongs to the group of respiration inhibitors classified by US EPA and Canada PMRA as succinate dehydrogenase inhibitors (SDHI) which is classified by FRAC as a Group 7 fungicide

Application Instructions

• Thorough and uniform coverage is required for optimum performance

• Revylok fungicide can be applied by ground or air and through sprinkler irrigation (chemigation) systems

• Application equipment, including injection systems, must be cleaned thoroughly before and after applying this product, particularly if a product with the potential to injure crops was used before application of Revylok fungicide Flush system with clean water

Ground Application

- Provides the most thorough and uniform coverage - Use a minimum of 10 gallons of spray solution per acre to ensure uniform and thorough canopy penetration and coverage of foliage, bloom and fruit - Adjust spray volume and application equipment for uniform and thorough canopy penetration and coverage of foliage, bloom and fruit - Refer to crop-specific requirements for in-furrow instructions Revylok label rates specify the amount of product to apply uniformly over an acre of ground on a broadcast basis Revylok may be banded over rows or plant beds with alleys or row middles left unsprayed For these uses, reduce rates of Revylok in proportion to the area sprayed to avoid application at higher than labeled use rates