UPI Dicamba
- Manufacturer
- United Phosphorus
- Category
- Herbicides
- Registered until
- N/A
- Registration number
- 70506-244
- Links
- LabelView
DIRECTIONS FOR USE
IT IS A VIOLATION OF FEDERAL LAW TO USE THIS PRODUCT IN A MANNER INCONSISTENT WITH ITS LABELING.
For any requirements specific to your State or tribe, consult the agency responsible for pesticide regulation. Do not apply this product in a way that will contact workers or other persons, either directly or through drift. Only protected handlers may be in the area during application.
INFORMATION
The following directions apply to all uses of UPI DICAMBA. Additional precautions and restrictions will be found in each specific use section.
Do not treat irrigation ditches or water used for crop irrigation or domestic uses.
Do not apply this product through any type of irrigation system.
Mixing and Application
UNLESS OTHERWISE SPECIFIED UNDER THE INDIVIDUAL USE HEADINGS OF THIS BOOKLET, THE FOLLOWING DIRECTIONS APPLY TO ALL CROP AND NON-CROP USES OF UPI DICAMBA. REFER TO INDIVIDUAL USE SECTIONS FOR ADDITIONAL PRECAUTIONS, RESTRICTIONS, APPLICATION RATES AND TIMINGS.
UPI DICAMBA is a water-soluble formulation that can be applied using water or sprayable fluid fertilizer as the carrier. If a fluid fertilizer is to be used, a compatibility test (see COMPATIBILITY TEST on page 6) should be made prior to tank mixing.
Ground or aerial application equipment which will give good spray coverage of weed foliage should be used. HOWEVER, DO NOT USE AERIAL APPLICATION EQUIPMENT IF SPRAY PARTICLES CAN BE CARRIED BY WIND INTO AREAS WHERE SENSITIVE CROPS OR PLANTS ARE GROWING OR WHEN TEMPERATURE INVERSIONS EXIST.
Apply 3 to 50 gallons of a diluted spray per treated acre when using ground application equipment, or 1 to 10 gallons of a diluted spray per treated acre (2 to 20 gallons of diluted spray per acre for preharvest uses) in a water-based carrier when using aerial application equipment. Use the higher level of the listed spray volumes when treating dense or tall vegetation. Use coarse sprays. Select nozzles designed to produce minimal amounts of fine spray particles. Spray with nozzles as close to the weeds as is practical for good weed coverage.
To avoid uneven spray coverage, do not apply this product during periods of gusty wind or when wind is in excess of 15 mph.
Avoid disturbing (e.g. cultivating or mowing) treated areas for at least 7 days following application.
Registered for cultures |
---|
Corn |
Cotton |
Sorghum |
Fallow |
Sugarcane |
Asparagus |
Winter wheat |
Spring wheat |
Spring barley |
Winter barley |