Willowood Bifenthrin 2ECPlant Protection Product ComparisonPlant Protection Product ComparisonReport inaccuraciesReport inaccuracies

DIRECTIONS FOR USE
It is a violation of Federal law to use this product in a manner inconsistent with its labeling.
Do not apply this product in a way that will contact workers or other persons, either directly or through drift. Only
protected handlers may be in the area during application. For any requirements specific to your State or Tribe, consult the
agency responsible for pesticide regulation.

RESISTANCE MANAGEMENT
Willowood Bifenthrin 2EC contains a Group 3 Insecticide. With repeated use of Group 3 insecticide as the primary method
of control in the same field or in successive years, insect/mite populations can develop resistant biotypes. If this occurs,
insect/mite biotypes with acquired resistance to Group 3 insecticides may eventually dominate the insect/mite population.
This may result in partial or total loss of control of those species by Willowood Bifenthrin 2EC or other Group 3
insecticides.

APPLICATIONS INSTRUCTIONS
The rate of Willowood Bifenthrin 2EC applied will vary according to pest pressure and timing of application. Use lower
rates under light to moderate infestations and higher rates under heavy insect pressure and for mite control. Arid climates
generally-require-higher rates.
Unless otherwise specified for a specific crop, apply when pest population reaches economic (damaging) threshold and
repeat as necessary to maintain control. Thorough coverage is essential to achieve controf.
In the COMMENTS section of the label for each crop, the application rate when applied by ground and/or air is listed as
an amount of spray per acre. In all cases, this refers to finished spray per acre.