Bifenthrin

Manufacturer
Kenso Corporation
Category
Insecticides
Registered until
2024-06-30
Registration number
69277
Active materials
Links

GENERAL INSTRUCTIONS- AGRICULTURAL CROPS

Kenso Agcare Bifenthrin Termiticide & Insecticide is a contact and residual insecticide/miticide. It can be used as a protective treatment when applied at regular intervals or as a knockdown treatment to control existing pests. Best results are obtained when applied before pest populations build up to damaging levels. This product is not suitable for use in Integrated Pest Management (IPM) programs where mite predators are established and providing effective mite control.

APPLICATION

Kenso Agcare Bifenthrin Termiticide & Insecticide may be applied by ground rig or aircraft. Thorough coverage is essential to ensure adequate control. DO NOT apply as a fog or mist.

DILUTE SPRAYING:

  • Use a sprayer designed for high water volumes.
  • Set up and operate the sprayer for even coverage throughout the crop canopy.
  • Apply sufficient water to cover the crop to the point of run-off, avoiding excessive run-off.
  • Determine water volume using industry guidelines or expert advice.
  • Add the specified product amount per 100 L of water and spray to the point of run-off.
  • Adjust dilute spray volume and sprayer setup as the crop grows.

CONCENTRATE SPRAYING: (a) Use a sprayer designed for concentrate spraying. (b) Achieve even coverage using the chosen water volume. (c) Determine an appropriate dilute spray volume for the crop canopy. (d) Calculate the concentrate mixing rate based on the dilute label rate.

For further information on concentrate spraying, consult relevant industry guidelines, undertake appropriate competency training, and follow industry Best Practices.

GROUND APPLICATION:

  • Apply as a fine spray with hollow cone nozzles and a droplet size of 150 to 200 microns.
  • Application volume varies based on the crop type.

AERIAL APPLICATION:

  • Use at least 20 L/ha of total spray volume.
  • Spray during cooler parts of the day or night.
  • Avoid spraying in calm conditions or light and variable winds.
  • Employ a spray drift minimization strategy, especially near sensitive areas.

MONITORING:

  • Post-emergence monitoring of Citrus leafeating weevil populations is recommended.
  • Conduct regular inspections, especially in high-risk termite areas.

MIXING:

  • Add the required quantity of Kenso Agcare Bifenthrin Termiticide & Insecticide to water in the spray tank and mix thoroughly.
  • Maintain agitation during mixing and application.

COMPATIBILITY:

  • Compatible with commonly used fungicides and herbicides.
  • Additional surfactant may be necessary on hard-to-wet plants and in high volume situations.

STONE FRUIT EXPORT ADVICE:

  • Some export markets may lack suitable Maximum Residue Limits or Import Tolerances. Contact Kenso Agcare or the Australian Fresh Stone Fruit Growers Association before using on export-bound crops.

RE-ENTRY TO TREATED FIELDS/CROPS:

  • DO NOT re-enter treated fields/crops until spray deposits have dried, unless wearing suitable protective clothing.

PROTECTION OF WILDLIFE, FISH, CRUSTACEANS, AND THE ENVIRONMENT:

  • Dangerous to fish and aquatic organisms.
  • DO NOT contaminate dams, rivers, streams, waterways, or drains.

PROTECTION OF PETS AND LIVESTOCK:

  • Remove animals and pets from treated areas before spraying.
  • Cover or remove open food and water containers.

SAFETY DIRECTIONS – AGRICULTURAL CROPS:

  • Poisonous if swallowed. Attacks eyes. Will irritate the skin.
  • Wear protective clothing during preparation and use.
  • Wash hands after use and launder contaminated clothing after each day's use.
Registered for culturesRate
Bananas0 l
Clover0.05 - 0.2 l
Spring barley0.05 - 0.2 l
Winter barley0.05 - 0.2 l
Canola0.05 - 0.2 l
Lupines0.05 - 0.2 l
Winter wheat0.05 - 0.2 l
Spring wheat0.05 - 0.2 l
Peaches0 l
Nectarines0 l
Apricots0 l
Citrus0 l
Cotton0.6 - 0.8 l
Navy beans0.6 - 0.8 l
Pears0 l
Tomatoes0 l
Sugarcane0 l