Kentrole 250Plant Protection Product ComparisonPlant Protection Product ComparisonReport inaccuraciesReport inaccuracies

GENERAL INSTRUCTIONS Before opening, carefully read Safety Directions, First Aid Instructions, Directions for Use, Storage and Disposal, and Protection Statements.

APPLICATION INFORMATION Thoroughly wet all surfaces by aiming to apply 1700 - 2200 L/ha with power spraying equipment, 900 - 1100 L/ha (1 litre per 10m2) using a knapsack, and 170 L/ha when using a misting machine. Note: Misting machines are not recommended for use in Tasmania.

MIXING INSTRUCTIONS To improve the efficiency of this product, it is recommended that a surfactant be added to the spray mixture at the following rates:

• Power Spraying: 250 mL/100 L spray mixture

• Knapsack Spraying: 5 mL/15 L knapsack

• Misting Machine: 60 mL/15 L spray mixture (Not recommended in Tasmania) Note: The rates indicated in the Directions for Use table are per 100 L of water for power spraying. Refer to the chart below for the required amounts to suit other equipment.

RESISTANT WEEDS WARNING: Kenso Agcare Kentrole 250 Herbicide is a member of the triazole group of herbicides. Kenso Agcare Kentrole 250 Herbicide has the inhibition of lycopene cyclase mode of action. For weed resistance management, Kenso Agcare Kentrole 250 Herbicide is a Group 34 herbicide. Some naturally occurring weed biotypes resistant to Kenso Agcare Kentrole 250 Herbicide and other Group 34 herbicides may exist through normal genetic variability in any weed population. The resistant individuals can eventually dominate the weed population if these herbicides are used repeatedly. The effectiveness of Kenso Agcare Kentrole 250 Herbicide on resistant individuals could be significantly reduced. Since the occurrence of resistant weeds is difficult to detect prior to use, Kenso Corporation (M) Sdn. Bhd. accepts no liability for any losses that may result from the failure of Kenso Agcare Kentrole 250 Herbicide to control resistant weeds. Kenso Agcare Kentrole 250 Herbicide may be subject to specific resistance strategies. For further information, contact your local supplier, Kenso Corporation (M) Sdn. Bhd. representative, or local Department of Agriculture agronomist.

STORAGE AND DISPOSAL Store in the closed, original container in a cool, well-ventilated area. Do not store for prolonged periods in direct sunlight. Triple-rinse containers before disposal. Add rinsings to spray tank. Do not dispose of undiluted chemicals on-site. If recycling, replace cap and return clean containers to recycler or designated collection point. If not recycling, break, crush, or puncture and deliver empty packaging for appropriate disposal to an approved waste management facility. If an approved waste management facility is not available, bury the empty packaging 500 mm below the surface in a disposal pit specifically marked and set up for this purpose clear of waterways, desirable vegetation, and tree roots, in compliance with relevant Local, State, or Territory government regulations. Do not burn empty containers or product. For refillable containers (1000L), store the closed original container in a cool, well-ventilated area. Do not store for prolonged periods in direct sunlight. Empty contents fully into application equipment. Close all valves and return to the point of supply for refill or storage.