PickerPlant Protection Product ComparisonPlant Protection Product ComparisonReport inaccuraciesReport inaccuracies

COMPATIBILITY

When using Imtrade Picker Herbicide, adhere to regional restrictions and all directions and restrictions on the label of any chemical mixed with it. Imtrade Picker Herbicide is compatible with the following herbicides: 2,4-D Amine 500, Abound® 300, Dichloprop, Metsulfuron-methyl, Glyphosate 360 & 450, Glyphosate Ammonium, and Fluroxypyr. It is also compatible with the following adjuvants: ChemAg Wetter 1000, Pulse®, and Uptake® Spraying Oil, as per Directions for Use.

MIXING

Mix Imtrade Picker Herbicide only with water. Half-fill the spray unit with water, add the required amount of Imtrade Picker Herbicide, and then add the remaining water with the agitator running. If necessary, add spray oils or wetters (surfactants). Maintain mechanical or bypass agitation in the spray tank during spraying. Only mix enough solution for immediate daily use and avoid storing.

APPLICATION

1. WOODY WEED SITUATIONS

   • Ensure weeds are actively growing for optimum effect. Delay treatment until all re-growth has reached approximately 1 meter in situations like bulldozed, slashed, burnt, ploughed areas, or those previously treated with chemicals.

   • High Volume Spraying

     • Hand Gun: Apply recommended mix for full coverage of leaves and stems. Use a spray volume appropriate for the size and density of the infestation.

     • Aerial Application: Apply using an aircraft with proper nozzle configuration to produce droplets of 250 to 350 microns diameter.

   • Controlled Droplet Application (C.D.A.)

     • Use equipment like Micron Herbi to ensure proper droplet density.

   • Low Volume High Concentrate Application Techniques

     • Use gas-powered guns or sprinkler sprayers for effective coverage.

   • Boom Application

     • Use a minimum spray volume with flat fan nozzles and proper pressure settings.

2. FALLOW SITUATIONS

   • Boom Application

     • Use a minimum spray volume with flat fan nozzles and proper pressure settings.

   • Blanket Wiper Application

     • Use a durable wettable material as a blanket, mounted behind a motorized vehicle. Apply the chemical solution at a sufficient flow rate to keep the blanket wet but not dripping. Use scraping mechanisms for better coverage.

CLEANING SPRAY EQUIPMENT

After using Imtrade Picker Herbicide, rinse the spray unit completely and wash inside using a pressure hose. Thoroughly clean filters, pump, lines, hoses, and nozzles. Decontaminate before spraying sensitive crops with an alkali detergent and rinse thoroughly.

RESISTANT WEEDS WARNING

Imtrade Picker Herbicide is a Group 4 Herbicide, and resistant weed biotypes may exist. Employ strategies to minimize herbicide resistance and consult with relevant authorities or suppliers for guidance.

These instructions ensure the safe and effective use of Imtrade Picker Herbicide. Always follow label instructions for specific details and recommendations.