Propi Super 500Plant Protection Product ComparisonPlant Protection Product ComparisonReport inaccuraciesReport inaccuracies

GENERAL INSTRUCTIONS

Wheat - Stripe Rust - susceptible varieties: apply when 10% leaves infected. Wheat - Stripe Rust - moderately susceptible varieties: apply when 15 to 20% leaves infected.

Mixing

• Add the required amount directly to the spray tank and mix well.

• Pineapples - Pre-plant dip: Add the required amount of Kenso Agcare Propi Super 500 directly to the dip and mix well.

• Avoid excessive contamination of the dip with organic matter.

Application

• Cereals: May be applied by boom spray or aircraft. Ensure complete coverage of all leaves and stems is obtained. The object of spraying is to keep the upper 2 to 3 leaves green and functioning through grain filling stage.

• With aircraft, as a guide, apply 10 to 20 L/ha with the lower rate being used when applications are made with a cross wind of not less than 5 knots. Use the higher rates when applying to dense crops.

• Apricots, Plums and other Stone Fruit: Apply by high volume (dilute) sprayer or by concentrate sprayer.

Dilute spraying

• Use a sprayer designed to apply high volumes of water up to the point of run-off and matched to the crop being sprayed.

• Set up and operate the sprayer to achieve even coverage throughout the crop canopy. Apply sufficient water to cover the crop to the point of run-off. Avoid excessive run-off. The required water volume may be determined by applying different test volumes, using different settings on the sprayer, from industry guidelines or expert advice. Add the amount of product specified in the Direction for Use table for each 100 L of water. Spray to the point of run-off. The required dilute spray volume will change and the sprayer set up and operation may also need to be changed, as the crop grows.

Concentrate spraying

• Use a sprayer designed and set up for concentrate spraying (that is a sprayer which applies water volumes less than those required to reach the point of run-off) and matched to the crop being sprayed. Set up and operate the sprayer to achieve even coverage throughout the crop canopy using your chosen water volume. Determine an appropriate dilute spray volume (see Dilute spraying above) for the crop canopy. This is needed to calculate the concentrate mixing rate. The mixing rate for concentrate spraying can then be calculated in the following way:

  • EXAMPLE ONLY

    1. Dilute spray volume as determined above: for example 2000 L/ha

    2. Your chosen concentrate spray volume: for example 500 L/ha

    3. The concentration factor In this example is: 4 x (ie, 2000 L ÷ 500 L = 4)

    4. If the dilute label rate is 25 g/100 L, then the concentrate rate becomes 4 x 25, that is 100 g/100 L of concentrate spray.

• The chosen spray volume, amount of product per 100 L of water, and the sprayer set up and operation may need to be changed as the crop grows. For further information on concentrate spraying, users are advised to consult relevant industry guidelines, undertake appropriate competency training and follow industry Best Practices.

Compatibility

• Kenso Agcare Propi Super 500 is compatible with many commonly used orchard sprays which includes Ridomil Plus and some formulations of azinphos-methyl, demeton-s-methyl, diazinon, methomyI liquid, propargite, parathion, dimethoate, copper oxychloride, mancozeb, zineb and chlorothalonil. Mixtures with more than one of the above are not recommended.

PRECAUTION

Re-entry Period

• DO NOT enter treated area until spray has dried.

PROTECTION OF WILDLIFE, FISH, CRUSTACEANS AND ENVIRONMENT

• DO NOT contaminate streams, rivers or waterways with the chemical or used containers.

PROTECTION OF LIVESTOCK

• Low hazard to bees. No special precautions are required.