Tricky 600Plant Protection Product ComparisonPlant Protection Product ComparisonReport inaccuraciesReport inaccuracies

GENERAL INSTRUCTIONS:

RESISTANT WEEDS WARNING:

• GROUP I HERBICIDE:
  • AC Tricky 600 Herbicide belongs to the pyridines group with a disruptor of plant cell growth mode of action.
  • It is a Group I herbicide for weed resistance management.
  • Some naturally occurring weed biotypes resistant to AC Tricky 600 Herbicide may exist, and repeated use may lead to dominance by resistant weeds.
  • AC Tricky 600 Herbicide may not control resistant weeds; no liability is accepted for losses due to resistance.

COMPATIBILITY:

• Fallow Situations:
  • Compatible with 2,4D Amine or 2,4D Ester, Glyphosate 450, Lontrel Herbicide, Starane 200 Herbicide, Touchdown Broadacre, Chlorpyrifos Insecticide.
  • Check glyphosate label for use rate and recommended adjuvants when mixing with glyphosate in fallow.
  • DO NOT use Uptake Spray Oil or D-C Trate.

MINIMUM RECROPPING PERIODS:

• Check plant-back information on all product labels before tank mixing with other herbicides.
• Recropping periods for AC Tricky 600 Herbicide:
  • Wheat, barley, sorghum, maize: 7 days
  • Chickpeas, soybeans, sunflowers: 7 days
  • Cotton: 14 days

MIXING:

• Half fill the spray unit with water, add AC Tricky 600 Herbicide, and then add the remaining water with agitation.
• Add crop oils or wetters/surfactants last.
• Maintain mechanical or by-pass agitation during spraying.
• Mix only sufficient solution for immediate daily use and avoid storing prepared solutions.

APPLICATION INFORMATION:

1. WOODY WEED SITUATIONS:

   • Apply when weeds are actively growing.
   • Delay treatment until regrowth reaches one meter high in bulldozed, slashed, burnt, ploughed, or chemically treated areas.

   A. High Volume Spraying:

   • Thorough coverage is essential; avoid excess spraying.
   • Hand Gun: Use a No6 to 8 tip at 700-1500kPa.
   • Knapsack: Use for smaller infestations.

   B. Aerial Application:

   • Apply in 100 to 200L water per hectare with calibrated aircraft.
   • Avoid spraying when wind exceeds 10km/hr or air temperature reaches 30ºC.

   C. Controlled Droplet Application (CDA):

   • Use equipment like Micron Herbi for results similar to high volume spraying.

   D. Low Volume High Concentrate Application Techniques:

   • Good control similar to high volume application.
   • Gas Powered Gun: Apply 50mL shots for uniform coverage.
   • Sprinkler Sprayer: Use low pressures and a slow sweeping action for even coverage.

   E. Basal Bark and Cut Stump Treatment:

   • Wear nitrile gloves when mixing with diesel.
   • Basal Bark Method: Spray around the stem up to 30cm high.
   • Cut Stump Method: Liberally apply to freshly cut stump.

2. CROPPING/FALLOW SITUATIONS:

   • A. Boom Application:

     • Use a minimum spray volume of 50L/ha.
     • Flat fan nozzles recommended, with pressures of 200-300kPa.

   • B. Aerial Application:

     • Avoid physical drift onto desirable plants.
     • Minimum spray volume of 35L/ha with flat fan and CP nozzle configurations.
     • DO NOT apply by aircraft when wind exceeds 10km/hr or air temperature reaches 30ºC.