Ally 20 SG

Manufacturer
DU PONT
Category
Herbicides
Registered until
Registration expired
Registration number
31092
Active materials

FOR SALE FOR POSTEMERGENCE USE ON WHEAT (SPRING AND DURUM), BARLEY AND ESTABLISHED CREEPING RED FESCUE, ORCHARD GRASS, CRESTED AND INTERMEDIATE WHEAT GRASS (SEED OR FORAGE) IN THE PRAIRIE PROVINCES AND THE PEACE RIVER REGION OF BRITISH COLUMBIA (SOIL PH 7.9 OR LOWER) ONLY

DIRECTIONS FOR USE
IMPORTANT
Injury to or loss of desirable trees or vegetation may result from failure to observe the following: Do not apply, drain or flush equipment on or near desirable trees or other plants, or on areas where their roots may extend, or in locations where the chemical may be washed or moved into contact with their roots. Do not use on lawns, walks, driveways, tennis courts or similar areas. Prevent drift of spray to desirable plants. Do not contaminate any body of water, including irrigation water that may be used on other crops.
DO NOT APPLY BY AIR.
Carefully observe sprayer clean-up instructions, as spray tank residue may damage crops other than wheat, barley or creeping red fescue.
APPLY ALLY 20 SG HERBICIDE WITH RECOMMENDED SURFACTANT.
PRIOR TO USE REFER TO "MINIMUM CROP ROTATION GUIDELINES" SECTION OF LABEL.
When applied as a tank-mix combination, read and observe all label directions, including rates, restrictions, and grazing limitations for each product used in the tank-mix. Follow the more stringent label precautionary measures for mixing, loading and applying stated on both product labels.

GENERAL INFORMATION
ALLY 20 SG Herbicide is recommended for post-emergence use on wheat (spring and durum), barley and established creeping red fescue, orchard grass, crested and intermediate wheat grass (seed or forage) in the Prairie Provinces and the Peace River Region of British Columbia (soil pH of 7.9 or lower). ALLY 20 SG Herbicide is a 20% active ingredient herbicide formulated as a soluble granule. ALLY 20 SG Herbicide is to be mixed in water with a recommended surfactant and applied as a uniform broadcast spray. Use for selective control or suppression of certain broadleaf weeds in spring wheat (including durum), barley and established creeping red fescue (seed or forage). It is noncorrosive, nonflammable, nonvolatile and does not freeze. Wheat, barley or creeping red fescue may be grazed by or fed to livestock anytime after treatment.
Prior to using ALLY 20 SG Herbicide, careful consideration should be given to crop rotation plans. Crops other than those listed in the "Minimum Crop Rotation Guidelines" section can be very sensitive to low concentrations of ALLY 20 SG Herbicide in the soil. Refer to the "Minimum Crop Rotation Guidelines" section of this label to plan your ALLY 20 SG Herbicide use and crop rotations.
Rainfall, soil temperature and soil pH are important factors affecting ALLY 20 SG Herbicide breakdown in the soil. ALLY 20 SG Herbicide breakdown is more rapid under conditions of moist soil, warm soil temperatures and low soil pH. The breakdown process is slower under conditions of dry soil, cool soil temperatures and high soil pH.
ALLY 20 SG Herbicide must be applied with a recommended surfactant early postemergence to the main flush of actively growing broadleaf weeds. Warm, moist growing conditions promote active weed growth and enhance the activity of ALLY 20 SG Herbicide by allowing maximum foliar uptake and contact activity. If cold, dry conditions prevail, delay treatment until active weed growth resumes. Weeds hardened off by cold weather or drought stress may not be adequately controlled or suppressed and regrowth may occur. ALLY 20 SG Herbicide may only be applied with ground spray equipment. For best results, ensure good spray coverage of target weeds.
ALLY 20 SG Herbicide rapidly inhibits the growth of susceptible weeds, however, typical symptoms (discoloration) of dying weeds may not be noticeable for 1 to 3 weeks after application depending upon growing conditions and weed susceptibility. Degree of control and duration of effect depend on weed sensitivity, weed size, growing conditions, soil pH and spray coverage.
SURFACTANTS FOR USE WITH ALLY 20 SG Herbicide:
Ag-Surf, Agral 90, Companion, Citowett Plus, and Super Spreader Sticker are registered for use with ALLY 20 SG Herbicide, ALLY 20 SG Herbicide + 2,4-D, and ALLY 20 SG Herbicide + MCPA. Not all tank mixes require the use of an adjuvant. Use the surfactant at the rate of 2 L per 1000 L spray solution (0.2% v/v). See section-MIXING INSTRUCTIONS.

Registered for culturesRate
Spring wheat22.5 g
Winter barley22.5 g
Spring barley22.5 g