Chipco Sevin RP2 CarbarylPlant Protection Product ComparisonPlant Protection Product ComparisonReport inaccuraciesReport inaccuracies

DIRECTIONS FOR USE:
DO NOT APPLY BY AIR
IMPORTANT: The directions on this label are based on facts and field experience relating to (a) effectiveness; and (b) possible injury to plants and animals; and (c) residues in food, meat and milk. Follow directions for most effective use.

SPRAY PREPARATION:
TO ASSURE A UNIFORM PRODUCT, STIR OR SHAKE ALL CHIPCO SEVIN RP2 CONTAINERS PRIOR TO USE. Clean sprayer thoroughly before use.
Prepare only as much spray mixture as is needed on the day of mixing. Fill sprayer with 1/2 to 3/4 the desired amount of water. Slowly add the required amount of CHIPCO SEVIN RP2 and then the remaining volume of water. SHAKE SPRAY MIXTURES FREQUENTLY BEFORE AND DURING USE TO PREVENT SETTLING. Do not store spray mixtures overnight. To clean your sprayer after use, drain and flush with water. Do not use contaminated measuring devices for other purposes.

COMPATIBILITY:
CHIPCO SEVIN RP2, when diluted with an equal volume of water, is compatible with a wide range of pesticides. It is NOT compatible with diesel fuel, kerosene, fuel oil or aromatic solvents. If compatibility of CHIPCO SEVIN RP2 with another product and the resulting plant response is unknown, it should be tested on a small scale. Curdling, precipitation, greasing, layer formation or increased viscosity are symptoms of incompatibility. WHEN PREPARING COMBINATION SPRAYS, FIRST ADD CHIPCO SEVIN RP2 TO AT LEAST AN EQUAL VOLUME OF WATER, MIX THOROUGHLY, AND THEN ADD COMBINATION PRODUCTS TO THE MIXTURE. DO NOT APPLY COMBINATIONS UNLESS YOUR PREVIOUS EXPERIENCE INDICATES THE MIXTURE IS EFFECTIVE AND WILL NOT RESULT IN APPLICATION PROBLEMS, EXCESSIVE RESIDUES OR PLANT INJURY.
Unstable under highly alkaline conditions. Not effective if used with alkaline materials such as Bordeaux, lime-sulphur and certain lime spreaders.

INSECT CONTROL:
Apply when insects or their damage appear. To maintain control repeat at 7 to 10 day intervals or as necessary unless a shorter interval is specified on this label. When a dosage range is indicated, use lower rate on young plants and early instars and higher rate on mature plants, advanced instars and adults. Thorough and uniform spray coverage is essential for effective control. Avoid application just before rainfall as poor insect control may result.
CHIPCO SEVIN RP2 does not control spider mites. If spider mites are a problem, use a regular miticide.