FOR SALE FOR USE ON WHEAT (SPRING, WINTER OR DURUM), SPRING BARLEY AND OATS, AND SEEDLING AND ESTABLISHED GRASS SPECIES FOR FORAGE AND SEED PRODUCTION ONLY
Injury to or loss of desirable trees or vegetation may result from failure to observe the following: Do not apply, drain or flush equipment on or near desirable trees or other plants, or on areas where their roots may extend, or in locations where the chemical may be washed or moved into contact with their roots. Do not use on lawns, walks, driveways, recreational grounds or similar areas. Prevent drift of spray to desirable plants. Do not contaminate any body of water, including irrigation water that may be used on other crops.
DO NOT APPLY BY AIR.
Carefully observe sprayer clean-up instructions, as spray tank residues may damage crops other than wheat, barley or oats.
APPLY WITH A SURFACTANT REGISTERED FOR USE WITH NIMBLE Herbicide.
NIMBLE Herbicide is recommended for selective postemergence control or suppression of broadleaf weeds in wheat (spring, winter or durum), spring barley and oats not underseeded to legumes or grasses. NIMBLE Herbicide is a 75% active ingredient herbicide formulated as a water dispersible granule. NIMBLE Herbicide is to be mixed with water and a recommended surfactant and applied as a uniform broadcast spray. It is noncorrosive, nonflammable, nonvolatile and does not freeze.
NIMBLE Herbicide MUST be applied with a recommended surfactant, early postemergence, to the main flush of actively growing broadleaf weeds. Recommended surfactants are AGRAL 90, AG-SURF, CITOWETT PLUS and LIBERATE.
Warm, moist growing conditions promote active weed growth and enhance the activity of NIMBLE Herbicide by allowing maximum foliar uptake and contact activity. Weeds hardened off by cold weather or drought stress may not be adequately controlled or suppressed and regrowth may occur. For best results, ensure thorough spray coverage of target weeds. See "DIRECTIONS FOR USE" section of this label for complete use details. NIMBLE Herbicide stops growth of susceptible weeds rapidly. However, typical symptoms (discolouration) of dying weeds may not be noticeable for 1 to 3 weeks after application, depending upon growing conditions and weed susceptibility. Degree of control and duration of effect are dependent on weed sensitivity, weed size, crop competition, growing conditions at and following treatment, and spray coverage.
Canola, flax, lentils and alfalfa may be planted two months after an application of NIMBLE Herbicide. Any crop may be planted in the year following the use of NIMBLE Herbicide. One 320 g container of Nimble Herbicide treats 16 ha.
|Registered for cultures||Rate|
|Winter wheat||20 g|
|Spring wheat||20 g|
|Spring barley||20 g|
|Winter oats||20 g|
|Spring oats||20 g|