Store product in original container only.
Avoid contamination of seed, feed and foodstuffs.
Soak up small amounts with absorbent clays.
Sweep or scoop up spilled materials and dispose of in an approved landfill.
Wash down surfaces (floors, truckbeds, streets, etc.) with detergent and water solution.
Do not reuse this container for any purpose. This is a recyclable container, and is to be disposed of at a container collection site. Contact your local distributor/dealer or municipality for the location of the nearest collection site. Before taking the container to the collection site:
1) Triple- or pressure-rinse the empty container. Add the rinsings to the spray mixture in the tank.
2) Make the empty, rinsed container unsuitable for further use.
If there is no container collection site in your area, dispose of the container in accordance with provincial requirements.
Do not reuse this container for any other purpose. For disposal, this empty container may be returned to the point of purchase (distributor/dealer).
For disposal, this container may be returned to the point of purchase (distributor/dealer). It must be refilled by the distributor/dealer with the same product. Do not reuse this container for any other purpose.
For information on the disposal of unused, unwanted product, contact the manufacturer or the provincial regulatory agency. Contact the manufacturer and the provincial regulatory agency in case of a spill, or for the clean-up of spills.
When applied as directed under conditions described, this product controls undesirable vegetation listed on this label. This product also suppresses or controls undesirable vegetation listed on this label, when applied at recommended rates for release of established coniferous or deciduous species listed in the "Conifer Release" and "Deciduous Release" sections of this label.
This product may be applied using aerial and ground spray or wiper equipment for silvicultural site preparation, rights of ways, and conifer release, and ground spray or wiper equipment for deciduous release, forest road-side vegetation management and forest tree planting nurseries. Woody vegetation may be controlled by injection application of this product. See the "Mixing", "Application Instructions" and "Selective Equipment" sections of this label for information on how to properly apply this product.
For herbaceous weeds, woody brush, and trees controlled, see the "Vegetation Controlled" section of this label.
For specific site preparation instructions, see the "Site Preparation, Forest Roadside and Rights of Way Vegetation Management" section of the label.
For specific conifer or deciduous release instructions see the "Conifer Release" or "Deciduous Release" sections of this label.
Treatments should not be made to trees or brush after fall leaf drop has begun.
For specific forest tree planting nursery instructions, see the "Forest Tree Planting Nurseries" section of this label.
For specific injection application instructions, see the "Injection Applications" section of this label.
For specific instructions on use of wick or wiper applicators for vegetation control, see the "Selective Equipment" section of this label.
This product moves through the plant from the point of foliage contact to and into the root system. Visible effects on most annual weeds occur within 2 to 4 days, but on most susceptible perennial weeds, trees and woody brush, may not occur until 7 to 14 days. Extremely cool or cloudy weather at treatment time may slow down activity of this product and delay visual effects or control. Visible effects are a gradual wilting and yellowing of the plant which advance to complete browning of above-ground growth and deterioration of underground plant parts.
Delay application until vegetation has emerged to the stages described for control of such vegetation under the "Vegetation Controlled" section of this label to provide adequate leaf surface to receive the spray. Unemerged plants arising from underground rhizomes or root stocks of perennials will not be affected by the spray and will continue to grow. For this reason best control of most perennial herbaceous vegetation is obtained when treatment is made at late growth stages approaching maturity.
Always use the higher rate of this product per hectare within the recommended range on hard to control species or when vegetation growth is heavy or dense.
Do not treat vegetation under poor growing conditions such as drought stress, disease or insect damage as reduced vegetation control may result. Reduced results may also occur when treating vegetation heavily covered with dust.
Rainfall occurring soon after application may reduce effectiveness. Heavy rainfall within 2 hours after application may wash the product off the foliage and a repeat treatment may be required.
Do not mix with any surfactant, pesticide, herbicide oils or any other material other than water unless specified in this label.
For best results spray coverage should be uniform and complete. Do not spray weed foliage to the point of runoff.
This product mixes readily with water.
For ground, aerial or industrial type sprayers, fill the spray tank with one half the required amount of water. Add the proper amount of herbicide (see "Application Instructions" section of the label) and mix well before adding the remaining portion of water. Placing the filling hose below the surface of the liquid solution will prevent excessive foaming. Removing hose from tank immediately will avoid back siphoning into to water source. Use of mechanical agitators may cause excessive foaming. By-pass lines should terminate at the bottom of the tank. For use in knapsack sprayers, it is suggested that the proper amount of this herbicide be mixed with water in a larger container. Fill sprayer with the mixed solution.
NOTE: REDUCED RESULTS MAY OCCUR IF WATER CONTAINING SOIL IS USED, SUCH AS WATER FROM PONDS AND UNLINED DITCHES.
APPLY THESE SPRAY SOLUTIONS IN PROPERLY MAINTAINED AND CALIBRATED EQUIPMENT CAPABLE OF DELIVERING DESIRED VOLUMES. HAND GUN APPLICATIONS SHOULD BE PROPERLY DIRECTED TO AVOID SPRAYING DESIRABLE PLANTS.
AVOID DRIFT. Drift may cause damage to any vegetation contacted for which treatment is not intended. Applications in wind conditions in excess of local and/or provincial aerial spray regulations are not recommended.
To prevent injury to adjacent vegetation, appropriate buffer zones must be maintained.
Do not apply directly to any body of water populated with fish or used for domestic purposes. Do not use in areas where adverse impact on domestic water or aquatic species is likely.
|Registered for cultures||Rate|
|Glyphosate who kills all plants||3 - 12 l|