Gallant 1.6LPlant Protection Product ComparisonPlant Protection Product ComparisonReport inaccuraciesReport inaccuracies

DIRECTIONS FOR USE
It is a violation of Federalllaw to use this product in a manner inconsistent with its labeling.
Do not apply this product'in a way that will contact workers or other persons, either directly or through drift. Only protected handlers may be in the area during application. For any requirements specific to your State or Tribe, consult the agency responsible for pesticide regulation.

APPLICATION DIRECTIONS
DO Not Apply Imidacloprid 1.6L AG in Enclosed Structures Such as Greenhouses or Planthouses.
Apply IMIDACLOPRID 1.6L AG as a directed or broadcast foliar spray. Thorough coverage of foliage without runoff is required for maximum insecticidal efficacy. Use of adequate spray volumes and correctly calibrated application equipment is critical. Use of a spray adjuvant may enhance thorough coverage.
Lack of adequate coverage and retention of IMIDACLOPRID 1.6L AG on foliage and fruit can delay or lessen insect control. IMIDACLOPRID 1.6L AG may be applied with ground or aerial application equipment that has been properly calibrated.
Minimum spray volumes (unless otherwise specified on crop sections) are:
• 10 gallons/Acre by ground application
• 5 gallons/Acre through aerial equipment.
IMIDACLOPRID 1.6L AG may also be applied by overhead chemigation (see CHEMIGATION DIRECTIONS FOR USE section below) if allowed.in crop specific application sections. IMIDACLOPRID 1.6L AG application to crops grown for production of true seed intended for private or commercial planting may be allowed under State specific 24(c) labeling. Additional information on
IMIDACLOPRID 1.6L AG uses for these crops and other questions may be obtained from the
Cooperative Extension Service, PCAs, consultants or local Albaugh representatives.
RESTRICTIONS: Do not apply more than 0.5 Ibs. active ingredient per acre, per year, regardless of formulation or method of application, unless specified within a crop specific applications section for a given crop.

Mixing Instructions
1. Add a 50% of the required amount of water to the spray tank
2. Begin agitation
3. Add labeled rate of IMIDACLOPRID 1.6L AG
4. Add balance of water needed.
Maintain sufficient agitation during both mixing and application. IMIDACLOPRID 1,6L AG may be tank mixed with other pesticides and/or fertilizer solutions. Refer to Compatibility Note below. When tank mixing IMIDACLOPRID 1.6L AG with other pesticides, prepare the tank mixture as recommended above
and follow suggested Mixing Order below.

Mixing Order for Tank Mixes 
1. Wettable powders
2. IMIDACLOPRID 1.6L AG, or other flowables second,
3. Emulsifiable concentrates ,

Maintain good agitation as each pesticide is added. Do not add the next product until the previous is thoroughly mixed. If a fertilizer solution is added, a fertilizer pesticide compatibility agent may be needed. Maintain constant agitation during both mixing and application to ensflre uniformity of spray mixture.

Compatibility Note
Unless the applicator has prior knowledge of the compatibility of the intended tank mixture, Albaugh recommends a small scale test by adding proportionate amounts of each ingredient in the appropriate order, to a clear pint or quart sized jar. Cap and shake for 5 minutes, then let set for 5 minutes. Any visual indication of poor mixing or formation of precipitates that cannot be easily re-dispersed indicates incompatibility and the mixture that should not be used.