Grizzly Z Insecticide
DIRECTIONS FOR USE
RESTRICTED USE PESTICIDE
It is a violation of Federal law to use this product in a manner inconsistent with its labeling. Do not apply this product in a way that will contact workers or other persons, either directly or through drift. Only protected handlers may be in the area during application. For any requirements specific to your State or Tribe, consult the agency responsible for pesticide regulation. This labeling must be in the possession of the user at the time of application
GENERAL DIRECTIONS FOR USE
Initial and residual control are contingent upon thorough crop coverage. Apply with ground or air equipment using sufficient water to obtain full coverage of foliage. Apply in a minimum of 2 gals./A by air or 10 gals./A by ground unless otherwise specified in this label. When foliage is dense or pest pressure is high (heavier insect or egg pressure, larger larval stages), use of higher application volumes and/or higher use rates may improve initial and residual control.
For cutworm control, Grizzly Z Insecticide may be applied before, during, or after planting. For soil incorporated applications, use higher rates for improved control.
Some insects are known to develop resistance to products used repeatedly for control. Because the development of resistance cannot be predicted, the use of this product should conform to resistance management strategies established for the use area. Consult your local or state agricultural authorities for details.
If resistance to this product develops in your area, this product, or other products with a similar mode of action, may not provide adequate control. If poor performance cannot be attributed to improper application or extreme weather conditions, a resistant strain of insect may be present. If you experience difficulty with control and resistance is a reasonable cause, immediately consult your local company representative or agricultural advisor for the best alternative method of control for your area.
TANK MIX APPLICATION
When tank mixing with any other agricultural products, always add Grizzly Z Insecticide last. Fill the tank with one half to two thirds volume of the mixing diluent. Make sure all other products are fully dispersed in the mixing diluent before adding the recommended rate of Grizzly Z Insecticide to the tank.
Add the remainder of the mixing diluent volume. It is recommended that mixing and spray equipment have continuous agitation for best results. Follow the precautions and limitations of the most restricted product in the tank mixture.
While Grizzly Z Insecticide has good flexibility for tank mixing with other agricultural products, a jar test for physical compatibility is recommended for untried mixtures using proper ratios and mixing sequences of all ingredients to be included in the mixture.
Grizzly Z Insecticide is an aqueous based formulation. It is recommended that no type of nonemulsifiable oils be used in combination with Grizzly Z Insecticide. If adjuvants are used, use only: Nonionic Surfactant (NIS) containing at least 75% surface agent, or
Non-phytotoxic Crop Oil Concentrate (COC), including once refined Vegetable Oil Concentrate (VOC),
Methylated Sunflower Oils (MSO) containing a minimum of 17% emulsifier.
Adjuvants other than NIS or COC may be used providing the product meets the following criteria:
1. Contains only EPA exempt ingredients.
2. Is non-phytotoxic to the target crop.
3. Is compatible in mixture. (May be established through a jar test.)
4. Is supported locally for use with Grizzly Z Insecticide on the target crop through proven field trials and through university and extension recommendations. In addition, the following may be used as diluents:
Crop Oil Concentrate; Methylated Sunflower Oils; Urea-Ammonium Nitrate
It is recommended that the following not be used in combination Grizzly Z Insecticide as diluents or adjuvants:
Non-emulsifiable oils; Diesel Fuel; Straight Mineral Oil
|Registered for cultures|