Imidan 60 WDGPlant Protection Product ComparisonPlant Protection Product ComparisonReport inaccuraciesReport inaccuracies

DIRECTIONS FOR USE
It is a violation of Federal law to use this product in a manner inconsistent with its labeling.
Do not apply this product in a way that will contact workers or other persons, either directly or through drift. Only protected handlers may be in the area during application. For any requirements specific to your State or Tribe, consult the agency responsible for pesticide regulation. Not for use in residential areas. Use in park or recreational areas is prohibited.

AGRICULTURAL USE REQUIREMENTS
Use this product only in accordance with its labeling and with the Worker Protection Standard, 40 CFR Part 170. This Standard contains requirements for the protection of agricultural workers on farms, forests, nurseries, and greenhouses, and handlers of agricultural pestiCides. It contains requirements for training, decontamination, notification, and emergency assistance. It also contains specific instructions and exceptions pertaining to the statements on this label about personal protective equipment (PPE) and restricted-entry interval. The requirements in this box only apply to uses of this product that are covered by the Worker Protection Standard. Do not enter or allow entry into treated areas during the restricted entry interval (REI). The REI for each crop is listed in the directions for use associated with each crop. PPE required for early entry to treated areas that is permitted under the Worker Protection Standard and that involves contact with anything that has been treated, such as plants, soil, or water is:
• Coveralls
• Shoes plus socks
• Chemical-resistant gloves made of any waterproof material
• Chemical-Resistant headgear for overhead exposure

DILUTION DIRECTIONS
The rate required for thorough, uniform coverage varies with plant growth at time of application. Apply recommended rate in adequate spray volumes to provide complete coverage of fruit and foliage.

MIXING DIRECTIONS
Please read and observe the following directions for use:
• Fill the tank Y, full of water.
• While agitating, add the required amount of Imidan 60-WDG
• Continue agitation for three and five minutes or until the Imidan 60-WDG is fully dispersed.
• Orice the Imidan 60-WDG is fully dispersed, maintain agitation and continue filling the tank with water. Imidan 60-WDG should be thoroughly mixed with water before adding any other material.
• As the tank is filling, add tank mix partners (if desired) then add the required volume of spray adjuvant. Always add the spray adjuvant last. Antifoaming agents may be used.

RESISTANCE MANAGEMENT
Imidan 60-WDG contains a Group 1 B insecticide. InsecUmite biotypes with acquired resistance to Group 1 B may eventually dominate the insecUmite population if Group 1 B insecticides are used repeatedly in the same field or in successive years as the primary method of control for targeted species. This may result in partial or total loss of control of those species by Imidan 60-WDG or other Group 1 B insecticides. To delay insecticide resistance consider: Avoiding the consecutive use of Imidan 60-WDG or other group 1 B insecticides that have a similar target site of action, on the same insect/mite species. Using tank-mixtures or premixes with insecticides from a different target site of action Group as long as the involved products are all registered for the same use and have different sites of action. Basing insecticide use on comprehensive IPM program. Monitoring treated insect/mite populations for loss of field efficacy. Contacting your local extension specialist, certified crop advisors, and/or manufacturer for insecticide resistance management and/or IPM recommendations for the specific site and resistant pest problems. For further information or to report suspected resistance, you may contact Gowan Company alto II free 1-800-883-1844.

USE LIMITATIONS
Do not exceed the maximum rate of phosmet per acre or the time limitations specified for the individual crops. Use in residential, park, or recreational areas is prohibited. Imidan 60-WDG is only for use in commercial agricultural crops and areas as listed. Do not apply to forests or natural fallow or wooded areas.