LPI Fenoxaprop-P-Ethyl

Loveland Products
Registered until
Registration number
Active materials

LPI Fenoxaprop-p-ethyl Herbicide is a postemergence herbicide for the control of Barnyardgrass, Green and Yellow foxtail (Pigeongrass), Volunteer and Wild millet species and Wild oat in barley and wheat (including durum wheat). LPI Fenoxaprop-p-ethyl Herbicide is also used for postemergence control of annual and perennial grassy weeds in several established perennial grass crops in Oregon, Utah and Washington only.

It is a violation of Federal law to use this product in a manner inconsistent with its labeling.
Do not use this product until you have read the entire label. Do not apply this product in a way that will contact workers or other persons, either directly or through drift. Only protected handlers may be in the area during application. For any requirements specific to your State or Tribe, consult the agency responsible for pesticide regulation.

Ground Application: DO NOT apply when winds are gusty, or when conditions will favor movement of spray particles off the desired spray target. To avoid drift and ensure consistent weed control, apply LPI Fenoxaprop-p-ethyl Herbicide with the spray boom as low as possible while maintaining a uniform spray pattern. Ten gallons of spray solution per acre is recommended. Under conditions where large grass weeds or dense weed populations are present or adverse environmental conditions exist, a greater spray volume of 15.0 to 20.0 gallons of spray solution per acre is required for best weed control. A minimum of 5.0 gallons of spray solution may only be used under conditions that are ideal for weed control. Herbicide applications can be negatively impacted by environmental conditions, weed populations and tank mix partners. Use a recommended spray pressure of 40 psi with flat-fan nozzle tips spaced 10 to 20 inches apart across the boom. Ground speed for application should not exceed 10 mph. To get uniform spray coverage, use nozzles to provide 200 to 350 micron size droplets. DO NOT apply with hollow cone type nozzles or other nozzles that produce a fine droplet spray.
Aerial Application: DO NOT make aerial applications in grass grown for seed. Calibrate the spray equipment prior to use. LPI Fenoxapropp-ethyl Herbicide should be applied in a minimum of 5.0 gallons of water per broadcast acre. To get uniform spray coverage, use nozzles to provide 200 to 350 micron size droplets. DO NOT use raindrop nozzles. Aerial applications with this product should be made at a maximum height of 10 feet above the crop with low drift nozzles at a maximum pressure of 40 psi. Avoid application under conditions where uniform coverage cannot be obtained or where excessive spray drift may occur.
Flagmen and loaders should avoid inhalation of spray mist and prolonged contact with skin.

Registered for cultures
Spring barley
Winter barley
Winter wheat
Spring wheat
Durum Wheat